lkml.org 
[lkml]   [2022]   [Jul]   [1]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
From
SubjectRe: [PATCH v4 12/15] pinctrl: Add AXP192 pin control driver
Date

Andy Shevchenko <andy.shevchenko@gmail.com> writes:

> On Wed, Jun 29, 2022 at 4:30 PM Aidan MacDonald
> <aidanmacdonald.0x0@gmail.com> wrote:
>>
>> The AXP192 PMIC's GPIO registers are much different from the GPIO
>> registers of the AXP20x and AXP813 PMICs supported by the existing
>> pinctrl-axp209 driver. It makes more sense to add a new driver for
>> the AXP192, rather than add support in the existing axp20x driver.
>>
>> The pinctrl-axp192 driver is considerably more flexible in terms of
>> register layout and should be able to support other X-Powers PMICs.
>> Interrupts and pull down resistor configuration are supported too.
>
> ...
>
>> +config PINCTRL_AXP192
>> + tristate "X-Powers AXP192 PMIC pinctrl and GPIO Support"
>> + depends on MFD_AXP20X
>> + select PINMUX
>> + select GENERIC_PINCONF
>> + select GPIOLIB
>> + help
>> + AXP PMICs provide multiple GPIOs that can be muxed for different
>> + functions. This driver bundles a pinctrl driver to select the function
>> + muxing and a GPIO driver to handle the GPIO when the GPIO function is
>> + selected.
>> + Say Y to enable pinctrl and GPIO support for the AXP192 PMIC.
>
> What will be the module name if compiled as a module?
>
> ...
>
>> +/**
>> + * struct axp192_pctl_function - describes a function that GPIOs may have
>> + *
>> + * @name: Function name
>> + * @muxvals: Mux values used for selecting this function, one per GPIO.
>> + * The i'th element corresponds to the i'th GPIO and is written
>> + * to the GPIO's control register field to select this function.
>> + * U8_MAX indicates that the pin does not support this function.
>> + * @groups: Array of @ngroups groups listing pins supporting this function.
>> + * @ngroups: Number of pin groups.
>> + */
>> +struct axp192_pctl_function {
>> + const char *name;
>> + /* Mux value written to the control register to select the function (-1 if unsupported) */
>> + const u8 *muxvals;
>> + const char * const *groups;
>> + unsigned int ngroups;
>> +};
>
> Can it be replaced by struct function_desc?
> https://elixir.bootlin.com/linux/latest/source/drivers/pinctrl/pinmux.h#L130

That'd work, but using the generic infrastructure doesn't allow me to
simplify anything -- I can eliminate three trivial functions, but the
generic code is higher overhead (extra allocations, radix trees, ...)
so I'd prefer to stick with the current approach.

>> + ret = devm_gpiochip_add_data(dev, &pctl->chip, pctl);
>> + if (ret)
>> + dev_err_probe(dev, ret, "Failed to register GPIO chip\n");
>
> Missed return.

Thanks for catching this, that was pretty silly of me...

\
 
 \ /
  Last update: 2022-07-01 17:38    [W:0.371 / U:0.944 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site