lkml.org 
[lkml]   [2022]   [May]   [12]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
From
SubjectRE: [PATCH v3 5/5] pinctrl: renesas: pinctrl-rzg2l: Add IRQ domain to handle GPIO interrupt
Date
Hi Prabhakar,

> Subject: Re: [PATCH v3 5/5] pinctrl: renesas: pinctrl-rzg2l: Add IRQ domain
> to handle GPIO interrupt
>
> Hi Biju,
>
> Thank you for the review.
>
> On Thu, May 12, 2022 at 6:35 AM Biju Das <biju.das.jz@bp.renesas.com>
> wrote:
> >
> > Hi Prabhakar,
> >
> > Thanks for the patch.
> >
> > > Prabhakar Mahadev Lad <prabhakar.mahadev-lad.rj@bp.renesas.com>
> > > Subject: [PATCH v3 5/5] pinctrl: renesas: pinctrl-rzg2l: Add IRQ
> > > domain to handle GPIO interrupt
> > >
> > > Add IRQ domian to RZ/G2L pinctrl driver to handle GPIO interrupt.
> > >
> > > GPIO0-GPIO122 pins can be used as IRQ lines but only 32 pins can be
> > > used as IRQ lines at given time. Selection of pins as IRQ lines is
> > > handled by IA55 (which is the IRQC block) which sits in between the
> GPIO and GIC.
> >
> > Do we need to update bindings with interrupt-cells on [1] like [2] as it
> act as parent for GPIO interrupts?
> >
> Yes interrupt-controller and interrupt-parent needs to be added. I'm
> wondering if "interrupt-cells" is not required. If the pin is an interrupt
> it will be passed as an GPIO.

It is same as external interrupt case right?

For eg:- Ethernet PHY case,

interrupt-parent = <&irqc>;
interrupts = <3 IRQ_TYPE_LEVEL_LOW>;

if you use GPIO, it will be like this right?

interrupt-parent = <&pinctrl>;
interrupts = <RZG2L_GPIO(43, 0) IRQ_TYPE_LEVEL_LOW>;

Cheers,
Biju






>
> @Geert - your thoughts ?
>
> Cheers,
> Prabhakar
\
 
 \ /
  Last update: 2022-05-12 19:59    [W:0.198 / U:0.128 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site