lkml.org 
[lkml]   [2022]   [Jan]   [24]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH] drm/msm/dp: always add fail-safe mode into connector mode list
Date
Some of DP link compliant test expects to return fail-safe mode
if prefer detailed timing mode can not be supported by mainlink's
lane and rate after link training. Therefore add fail-safe mode
into connector mode list as backup mode. This patch fixes test
case 4.2.2.1.

Signed-off-by: Kuogee Hsieh <quic_khsieh@quicinc.com>
---
drivers/gpu/drm/msm/dp/dp_panel.c | 5 +++++
1 file changed, 5 insertions(+)

diff --git a/drivers/gpu/drm/msm/dp/dp_panel.c b/drivers/gpu/drm/msm/dp/dp_panel.c
index 3b02922..7743b45 100644
--- a/drivers/gpu/drm/msm/dp/dp_panel.c
+++ b/drivers/gpu/drm/msm/dp/dp_panel.c
@@ -221,6 +221,11 @@ int dp_panel_read_sink_caps(struct dp_panel *dp_panel,
if (drm_add_modes_noedid(connector, 640, 480))
drm_set_preferred_mode(connector, 640, 480);
mutex_unlock(&connector->dev->mode_config.mutex);
+ } else {
+ /* always add fail-safe mode as backup mode */
+ mutex_lock(&connector->dev->mode_config.mutex);
+ drm_add_modes_noedid(connector, 640, 480);
+ mutex_unlock(&connector->dev->mode_config.mutex);
}

if (panel->aux_cfg_update_done) {
--
The Qualcomm Innovation Center, Inc. is a member of the Code Aurora Forum,
a Linux Foundation Collaborative Project
\
 
 \ /
  Last update: 2022-01-24 22:40    [W:0.036 / U:0.908 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site