lkml.org 
[lkml]   [2021]   [Dec]   [4]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
From
Subject[PATCH RFC V2 0/4] add Vertexcom MSE102x support
Date
This patch series adds support for the Vertexcom MSE102x Homeplug GreenPHY
chips [1]. They can be connected either via RGMII, RMII or SPI to a host CPU.
These patches handles only the last one, with an Ethernet over SPI protocol
driver.

The code has been tested only on Raspberry Pi boards, but should work
on other platforms.

Any comments about the code are welcome.

Changes in V2:
- improve lock handling for RX & TX path
- add new patch to introduce IF_PORT_HOMEPLUG as suggested by Andrew Lunn
- address all the comments by Jakub Kicinski, Andrew Lunn, Kernel test robot

[1] - http://www.vertexcom.com/p_homeplug_plc_en.html

Stefan Wahren (4):
dt-bindings: add vendor Vertexcom
dt-bindings: net: add Vertexcom MSE102x support
net: introduce media selection IF_PORT_HOMEPLUG
net: vertexcom: Add MSE102x SPI support

.../devicetree/bindings/net/vertexcom-mse102x.yaml | 71 ++
.../devicetree/bindings/vendor-prefixes.yaml | 2 +
drivers/net/ethernet/Kconfig | 1 +
drivers/net/ethernet/Makefile | 1 +
drivers/net/ethernet/vertexcom/Kconfig | 25 +
drivers/net/ethernet/vertexcom/Makefile | 6 +
drivers/net/ethernet/vertexcom/mse102x.c | 770 +++++++++++++++++++++
include/uapi/linux/netdevice.h | 3 +-
8 files changed, 878 insertions(+), 1 deletion(-)
create mode 100644 Documentation/devicetree/bindings/net/vertexcom-mse102x.yaml
create mode 100644 drivers/net/ethernet/vertexcom/Kconfig
create mode 100644 drivers/net/ethernet/vertexcom/Makefile
create mode 100644 drivers/net/ethernet/vertexcom/mse102x.c

--
2.7.4

\
 
 \ /
  Last update: 2021-12-04 14:18    [W:0.042 / U:16.496 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site