lkml.org 
[lkml]   [2020]   [Sep]   [9]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
From
Date
SubjectRe: [PATCH v2 6/6] drm/panel: Add Ilitek ILI9341 DBI panel driver
Hi Paul,

just a drive-by comment:

On Sat, Aug 22, 2020 at 6:33 PM Paul Cercueil <paul@crapouillou.net> wrote:

> + gpiod_set_value_cansleep(priv->reset_gpiod, 0);
> + usleep_range(20, 1000);
> + gpiod_set_value_cansleep(priv->reset_gpiod, 1);

This implies that the reset line is active low.

I would specify in the DT GPIO handle that it is active low
and invert the above.

So:

reset-gpios = <&gpio 4 GPIO_ACTIVE_LOW>;

gpiod_set_value_cansleep(priv->reset_gpiod, 1);
usleep_range(20, 1000);
gpiod_set_value_cansleep(priv->reset_gpiod, 0);

> + priv->reset_gpiod = devm_gpiod_get(dev, "reset", GPIOD_OUT_HIGH);
> + if (IS_ERR(priv->reset_gpiod)) {
> + dev_err(dev, "Couldn't get our reset GPIO\n");
> + return PTR_ERR(priv->reset_gpiod);
> + }

This would then fetch the GPIO as asserted (device in reset)
unless changed, but that may be the right thing to do actually.

> +static const struct ili9341_pdata yx240qv29_pdata = {
> + .mode = { DRM_SIMPLE_MODE(240, 320, 37, 49) },
> + .width_mm = 0, // TODO
> + .height_mm = 0, // TODO

When nothing else works and data sheets are incomplete I
just take out a ruler and measure on the actual device.

Yours,
Linus Walleij

\
 
 \ /
  Last update: 2020-09-09 14:18    [W:0.125 / U:1.404 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site