lkml.org 
[lkml]   [2020]   [Sep]   [3]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH v5 25/80] drm/vc4: crtc: Remove mode_set_nofb
Date
On BCM2711 to avoid stale pixels getting stuck in intermediate FIFOs, the
pixelvalve needs to be setup each time there's a mode change or enable /
disable sequence.

Therefore, we can't really use mode_set_nofb anymore to configure it, but
we need to move it to atomic_enable.

Reviewed-by: Dave Stevenson <dave.stevenson@raspberrypi.com>
Tested-by: Chanwoo Choi <cw00.choi@samsung.com>
Tested-by: Hoegeun Kwon <hoegeun.kwon@samsung.com>
Tested-by: Stefan Wahren <stefan.wahren@i2se.com>
Signed-off-by: Maxime Ripard <maxime@cerno.tech>
---
drivers/gpu/drm/vc4/vc4_crtc.c | 7 +------
1 file changed, 1 insertion(+), 6 deletions(-)

diff --git a/drivers/gpu/drm/vc4/vc4_crtc.c b/drivers/gpu/drm/vc4/vc4_crtc.c
index 284a85b9d7d4..2eda2e6429ec 100644
--- a/drivers/gpu/drm/vc4/vc4_crtc.c
+++ b/drivers/gpu/drm/vc4/vc4_crtc.c
@@ -376,11 +376,6 @@ static void vc4_crtc_config_pv(struct drm_crtc *crtc)
}
}

-static void vc4_crtc_mode_set_nofb(struct drm_crtc *crtc)
-{
- vc4_crtc_config_pv(crtc);
-}
-
static void require_hvs_enabled(struct drm_device *dev)
{
struct vc4_dev *vc4 = to_vc4_dev(dev);
@@ -433,6 +428,7 @@ static void vc4_crtc_atomic_enable(struct drm_crtc *crtc,
require_hvs_enabled(dev);

vc4_crtc_pixelvalve_reset(crtc);
+ vc4_crtc_config_pv(crtc);

CRTC_WRITE(PV_CONTROL, CRTC_READ(PV_CONTROL) | PV_CONTROL_EN);

@@ -791,7 +787,6 @@ static const struct drm_crtc_funcs vc4_crtc_funcs = {
};

static const struct drm_crtc_helper_funcs vc4_crtc_helper_funcs = {
- .mode_set_nofb = vc4_crtc_mode_set_nofb,
.mode_valid = vc4_crtc_mode_valid,
.atomic_check = vc4_crtc_atomic_check,
.atomic_flush = vc4_hvs_atomic_flush,
--
git-series 0.9.1
\
 
 \ /
  Last update: 2020-09-03 10:11    [W:0.413 / U:2.660 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site