lkml.org 
[lkml]   [2020]   [Sep]   [24]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
SubjectRe: [PATCH v2 0/2] Add support for MMC/SD on j7200-evm
From
Date


On 9/24/20 4:56 PM, Faiz Abbas wrote:
> The following patches add dt support for MMC/SD on TI's j7200-evm.
>
> Currently, eMMC support upto HS200 speed and SD card supports upto high
> speed speed mode.
>
> v2:
> Fixed node names to use mmc@* format
> Fixed reg address format to align with others in the file
>
> Faiz Abbas (2):
> arm64: dts: ti: k3-j7200-main: Add support for MMC/SD controller nodes
> arm64: dts: ti: k3-j7200-common-proc-board: Add support for eMMC and
> SD card
>
> .../dts/ti/k3-j7200-common-proc-board.dts | 28 ++++++++++++++
> arch/arm64/boot/dts/ti/k3-j7200-main.dtsi | 37 +++++++++++++++++++
> 2 files changed, 65 insertions(+)
>
For the series:

Tested-by: Vignesh Raghavendra <vigneshr@ti.com>


[ 1.678263] mmc0: Command Queue Engine enabled
[ 1.682727] mmc0: new HS200 MMC card at address 0001
[ 1.688193] mmcblk0: mmc0:0001 S0J56X 14.8 GiB
[ 1.692971] mmcblk0boot0: mmc0:0001 S0J56X partition 1 31.5 MiB
[ 1.699138] mmcblk0boot1: mmc0:0001 S0J56X partition 2 31.5 MiB
[ 1.705268] mmcblk0rpmb: mmc0:0001 S0J56X partition 3 4.00 MiB, ch
ardev (240:0)
[ 1.789527] mmc1: new high speed SDHC card at address aaaa
[ 1.795621] mmcblk1: mmc1:aaaa SC16G 14.8 GiB
[ 1.810074] mmcblk1: p1 p2


SD hot plug works fine too..
Full log: https://pastebin.ubuntu.com/p/5hcCQDjhtW/

\
 
 \ /
  Last update: 2020-09-24 13:59    [W:0.062 / U:4.328 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site