lkml.org 
[lkml]   [2020]   [Aug]   [30]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH v3 3/3] misc: eeprom: at24: register nvmem only after eeprom is ready to use
Date
During nvmem_register() the nvmem core sends notifications when:

- cell added
- nvmem added

and during these notifications some callback func may access the nvmem
device, which will fail in case of at24 eeprom because regulator and pm
are enabled after nvmem_register().

Signed-off-by: Vadym Kochan <vadym.kochan@plvision.eu>
---
v3:
1) at24 driver enables regulator and pm state machine after nvmem
registration which does not allow to use it on handing NVMEM_PRE_ADD event.

drivers/misc/eeprom/at24.c | 11 +++++++----
1 file changed, 7 insertions(+), 4 deletions(-)

diff --git a/drivers/misc/eeprom/at24.c b/drivers/misc/eeprom/at24.c
index 2591c21b2b5d..26a23abc053d 100644
--- a/drivers/misc/eeprom/at24.c
+++ b/drivers/misc/eeprom/at24.c
@@ -692,10 +692,6 @@ static int at24_probe(struct i2c_client *client)
nvmem_config.word_size = 1;
nvmem_config.size = byte_len;

- at24->nvmem = devm_nvmem_register(dev, &nvmem_config);
- if (IS_ERR(at24->nvmem))
- return PTR_ERR(at24->nvmem);
-
i2c_set_clientdata(client, at24);

err = regulator_enable(at24->vcc_reg);
@@ -708,6 +704,13 @@ static int at24_probe(struct i2c_client *client)
pm_runtime_set_active(dev);
pm_runtime_enable(dev);

+ at24->nvmem = devm_nvmem_register(dev, &nvmem_config);
+ if (IS_ERR(at24->nvmem)) {
+ pm_runtime_disable(dev);
+ regulator_disable(at24->vcc_reg);
+ return PTR_ERR(at24->nvmem);
+ }
+
/*
* Perform a one-byte test read to verify that the
* chip is functional.
--
2.17.1
\
 
 \ /
  Last update: 2020-08-31 03:56    [W:0.081 / U:9.056 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site