Messages in this thread |  | | Date | Fri, 10 Jul 2020 10:24:01 -0600 | From | Rob Herring <> | Subject | Re: [PATCH 3/6] dt-bindings: thermal: tsens: document ipq8064 bindings |
| |
On Thu, 09 Jul 2020 23:51:33 +0200, Ansuel Smith wrote: > Document the use of regmap phandle for ipq8064 SoCs > > Signed-off-by: Ansuel Smith <ansuelsmth@gmail.com> > --- > .../bindings/thermal/qcom-tsens.yaml | 51 ++++++++++++++++--- > 1 file changed, 44 insertions(+), 7 deletions(-) >
My bot found errors running 'make dt_binding_check' on your patch:
Documentation/devicetree/bindings/thermal/qcom-tsens.example.dts:21.38-31.11: Warning (unit_address_vs_reg): /example-0/thermal-sensor@900000: node has a unit name, but no reg or ranges property /builds/robherring/linux-dt-review/Documentation/devicetree/bindings/thermal/qcom-tsens.example.dt.yaml: thermal-sensor@900000: interrupts: [[0, 178, 4]] is too short /builds/robherring/linux-dt-review/Documentation/devicetree/bindings/thermal/qcom-tsens.example.dt.yaml: thermal-sensor@900000: '#qcom,sensors' is a required property /builds/robherring/linux-dt-review/Documentation/devicetree/bindings/thermal/qcom-tsens.example.dt.yaml: thermal-sensor@900000: 'interrupt-names' is a required property /builds/robherring/linux-dt-review/Documentation/devicetree/bindings/thermal/qcom-tsens.example.dt.yaml: thermal-sensor@900000: compatible: ['qcom,ipq8064-tsens'] is not valid under any of the given schemas (Possible causes of the failure): /builds/robherring/linux-dt-review/Documentation/devicetree/bindings/thermal/qcom-tsens.example.dt.yaml: thermal-sensor@900000: compatible: ['qcom,ipq8064-tsens'] is too short /builds/robherring/linux-dt-review/Documentation/devicetree/bindings/thermal/qcom-tsens.example.dt.yaml: thermal-sensor@900000: compatible:0: 'qcom,ipq8064-tsens' is not one of ['qcom,msm8976-tsens', 'qcom,qcs404-tsens'] /builds/robherring/linux-dt-review/Documentation/devicetree/bindings/thermal/qcom-tsens.example.dt.yaml: thermal-sensor@900000: compatible:0: 'qcom,ipq8064-tsens' is not one of ['qcom,msm8996-tsens', 'qcom,msm8998-tsens', 'qcom,sc7180-tsens', 'qcom,sdm845-tsens']
/builds/robherring/linux-dt-review/Documentation/devicetree/bindings/thermal/qcom-tsens.example.dt.yaml: thermal-sensor@900000: nvmem-cell-names:1: 'calib_sel' was expected
See https://patchwork.ozlabs.org/patch/1326228
If you already ran 'make dt_binding_check' and didn't see the above error(s), then make sure dt-schema is up to date:
pip3 install git+https://github.com/devicetree-org/dt-schema.git@master --upgrade
Please check and re-submit.
|  |