[lkml]   [2020]   [Apr]   [5]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
Messages in this thread
SubjectRe: [PATCH] MIPS: malta: Set load address for 32bit kernel correctly
On Mon, 6 Apr 2020, Jiaxun Yang wrote:

> > Given the description above I think it should be done uniformly and
> >automatically across all platforms by trimming the address supplied
> >with
> >$(load-y) to low 8 digits in a single place, that is at the place where
> >
> >the variable is consumed. This will reduce clutter across Makefile
> >fragments, avoid inconsistencies and extra work to handle individual
> >platforms as the problem is triggered over and over again, and limit
> >the
> >risk of mistakes.
> I was intended to do like this but failed to find a proper way.
> Makefile isn't designed for any kind of calculation.
> And shell variables are 64-bit signed so it can't hold such a huge variable.
> Just wish somebody can give me a way to do like:
> ifndef CONFIG_64BIT
> load-y = $(load-y) & 0xffffffff
> endif

Use the usual shell tools like `sed', `cut', `awk', or whatever we use in
the kernel build already for other purposes. There's no need to do any
actual calculation here to extract the last 8 characters (and the leading
`0x' prefix). At worst you can write a small C program, compile it with
the build system compiler and run, as we already do for some stuff.


 \ /
  Last update: 2020-04-05 19:24    [W:0.046 / U:0.864 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site