lkml.org 
[lkml]   [2020]   [Apr]   [1]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
From
SubjectR: [PATCH 07/12] pcie: qcom: add tx term offset support
Date
> On Fri 20 Mar 11:34 PDT 2020, Ansuel Smith wrote:
>
> > From: Sham Muthayyan <smuthayy@codeaurora.org>
> >
> > Add tx term offset support to pcie qcom driver
> > need in some revision of the ipq806x soc
> >
> > Signed-off-by: Sham Muthayyan <smuthayy@codeaurora.org>
> > Signed-off-by: Ansuel Smith <ansuelsmth@gmail.com>
> > ---
> > drivers/pci/controller/dwc/pcie-qcom.c | 61
> ++++++++++++++++++++++----
> > 1 file changed, 52 insertions(+), 9 deletions(-)
> >
> > diff --git a/drivers/pci/controller/dwc/pcie-qcom.c
> b/drivers/pci/controller/dwc/pcie-qcom.c
> > index ecc22fd27ea6..8009e3117765 100644
> > --- a/drivers/pci/controller/dwc/pcie-qcom.c
> > +++ b/drivers/pci/controller/dwc/pcie-qcom.c
> > @@ -45,7 +45,13 @@
> > #define PCIE_CAP_CPL_TIMEOUT_DISABLE 0x10
> >
> > #define PCIE20_PARF_PHY_CTRL 0x40
> > +#define PHY_CTRL_PHY_TX0_TERM_OFFSET_MASK (0x1f << 16)
> > +#define PHY_CTRL_PHY_TX0_TERM_OFFSET(x) (x << 16)
> > +
> > #define PCIE20_PARF_PHY_REFCLK 0x4C
> > +#define REF_SSP_EN BIT(16)
> > +#define REF_USE_PAD BIT(12)
> > +
> > #define PCIE20_PARF_DBI_BASE_ADDR 0x168
> > #define PCIE20_PARF_SLV_ADDR_SPACE_SIZE 0x16C
> > #define PCIE20_PARF_MHI_CLOCK_RESET_CTRL 0x174
> > @@ -77,6 +83,18 @@
> > #define DBI_RO_WR_EN 1
> >
> > #define PERST_DELAY_US 1000
> > +/* PARF registers */
> > +#define PCIE20_PARF_PCS_DEEMPH 0x34
> > +#define PCS_DEEMPH_TX_DEEMPH_GEN1(x) (x << 16)
> > +#define PCS_DEEMPH_TX_DEEMPH_GEN2_3_5DB(x) (x << 8)
> > +#define PCS_DEEMPH_TX_DEEMPH_GEN2_6DB(x) (x << 0)
> > +
> > +#define PCIE20_PARF_PCS_SWING 0x38
> > +#define PCS_SWING_TX_SWING_FULL(x) (x << 8)
> > +#define PCS_SWING_TX_SWING_LOW(x) (x << 0)
> > +
> > +#define PCIE20_PARF_CONFIG_BITS 0x50
> > +#define PHY_RX0_EQ(x) (x << 24)
> >
> > #define PCIE20_v3_PARF_SLV_ADDR_SPACE_SIZE 0x358
> > #define SLV_ADDR_SPACE_SZ 0x10000000
> > @@ -97,6 +115,7 @@ struct qcom_pcie_resources_2_1_0 {
> > struct reset_control *phy_reset;
> > struct reset_control *ext_reset;
> > struct regulator_bulk_data
> supplies[QCOM_PCIE_2_1_0_MAX_SUPPLY];
> > + uint8_t phy_tx0_term_offset;
> > };
> >
> > struct qcom_pcie_resources_1_0_0 {
> > @@ -184,6 +203,16 @@ struct qcom_pcie {
> >
> > #define to_qcom_pcie(x) dev_get_drvdata((x)->dev)
> >
> > +static inline void
> > +writel_masked(void __iomem *addr, u32 clear_mask, u32 set_mask)
> > +{
> > + u32 val = readl(addr);
> > +
> > + val &= ~clear_mask;
> > + val |= set_mask;
> > + writel(val, addr);
> > +}
> > +
> > static void qcom_ep_reset_assert(struct qcom_pcie *pcie)
> > {
> > gpiod_set_value_cansleep(pcie->reset, 1);
> > @@ -277,6 +306,10 @@ static int
> qcom_pcie_get_resources_2_1_0(struct qcom_pcie *pcie)
> > if (IS_ERR(res->ext_reset))
> > return PTR_ERR(res->ext_reset);
> >
> > + if (of_property_read_u8(dev->of_node, "phy-tx0-term-offset",
> > + &res->phy_tx0_term_offset))
> > + res->phy_tx0_term_offset = 0;
>
> The appropriate way is to encode differences in hardware is to use
> different compatibles for the two different versions of the hardware.
>
> Regards,
> Bjorn
>

So a better way to handle this would be to check the SoC compatible?
AFAIK a different offset is only needed on ipq8064 revision 2 and ipq8065
but
it looks bad to add a special code just for that 2 SoC.
I would prefer to handle this with the offset definition but If you think
this would be
the right way, I will follow that. Waiting for your response about this.

> > +
> > res->phy_reset = devm_reset_control_get_exclusive(dev, "phy");
> > return PTR_ERR_OR_ZERO(res->phy_reset);
> > }
> > @@ -304,7 +337,6 @@ static int qcom_pcie_init_2_1_0(struct
> qcom_pcie *pcie)
> > struct qcom_pcie_resources_2_1_0 *res = &pcie->res.v2_1_0;
> > struct dw_pcie *pci = pcie->pci;
> > struct device *dev = pci->dev;
> > - u32 val;
> > int ret;
> >
> > ret = reset_control_assert(res->ahb_reset);
> > @@ -355,15 +387,26 @@ static int qcom_pcie_init_2_1_0(struct
> qcom_pcie *pcie)
> > goto err_deassert_ahb;
> > }
> >
> > - /* enable PCIe clocks and resets */
> > - val = readl(pcie->parf + PCIE20_PARF_PHY_CTRL);
> > - val &= ~BIT(0);
> > - writel(val, pcie->parf + PCIE20_PARF_PHY_CTRL);
> > + writel_masked(pcie->parf + PCIE20_PARF_PHY_CTRL, BIT(0), 0);
> > +
> > + /* Set Tx termination offset */
> > + writel_masked(pcie->parf + PCIE20_PARF_PHY_CTRL,
> > + PHY_CTRL_PHY_TX0_TERM_OFFSET_MASK,
> > + PHY_CTRL_PHY_TX0_TERM_OFFSET(res-
> >phy_tx0_term_offset));
> > +
> > + /* PARF programming */
> > + writel(PCS_DEEMPH_TX_DEEMPH_GEN1(0x18) |
> > + PCS_DEEMPH_TX_DEEMPH_GEN2_3_5DB(0x18) |
> > + PCS_DEEMPH_TX_DEEMPH_GEN2_6DB(0x22),
> > + pcie->parf + PCIE20_PARF_PCS_DEEMPH);
> > + writel(PCS_SWING_TX_SWING_FULL(0x78) |
> > + PCS_SWING_TX_SWING_LOW(0x78),
> > + pcie->parf + PCIE20_PARF_PCS_SWING);
> > + writel(PHY_RX0_EQ(0x4), pcie->parf + PCIE20_PARF_CONFIG_BITS);
> >
> > - /* enable external reference clock */
> > - val = readl(pcie->parf + PCIE20_PARF_PHY_REFCLK);
> > - val |= BIT(16);
> > - writel(val, pcie->parf + PCIE20_PARF_PHY_REFCLK);
> > + /* Enable reference clock */
> > + writel_masked(pcie->parf + PCIE20_PARF_PHY_REFCLK,
> > + REF_USE_PAD, REF_SSP_EN);
> >
> > ret = reset_control_deassert(res->phy_reset);
> > if (ret) {
> > --
> > 2.25.1
> >

\
 
 \ /
  Last update: 2020-04-01 23:56    [W:0.086 / U:5.928 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site