[lkml]   [2020]   [Apr]   [1]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
Messages in this thread
SubjectRE: [PATCH v4 2/7] tpm: tpm_tis: Add check_data handle to tpm_tis_phy_ops in order to check data integrity
>>On Tue, Mar 31, 2020 at 02:32:02PM +0300, wrote:
>> From: Amir Mizinski <>
>> In order to compute the crc over the data sent in lower layer (I2C
>> for instance), tpm_tis_check_data() calls an operation (if available)
>> to check data integrity. If data integrity cannot be verified, a retry
>> attempt to save the sent/received data is implemented.
>> The current steps are done when sending a command:
>> 1. Host writes to TPM_STS.commandReady.
>> 2. Host writes command.
>> 3. Host checks that TPM received data is valid.
>> 4. If data is currupted go to step 1.
>> When receiving data:
>> 1. Host checks that TPM_STS.dataAvail is set.
>> 2. Host saves received data.
>> 3. Host checks that received data is correct.
>> 4. If data is currupted Host writes to TPM_STS.responseRetry and go to
>> step 1.
>> Co-developed-by: Christophe Richard <>
>> Signed-off-by: Christophe Richard <>
>> Signed-off-by: Amir Mizinski <>

>The email is malformed.

>So.. How did Christophe participate on writing this patch? I haven't seen him shouting anything about the subject and still his SOB is there.


Christophe sent patch to support I2C TCG TPM driver tpm_tis_i2c ( in the same time that tpm_tis_spi. This function was named tpm_tis_i2c_check_data.

Best Regards,

 \ /
  Last update: 2020-04-01 22:21    [W:0.044 / U:0.444 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site