lkml.org 
[lkml]   [2020]   [Mar]   [31]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
From
SubjectRE: [PATCH] serial: sh-sci: Make sure status register SCxSR is read in correct sequence
Date
Hi Geert,

On Tue, Mar 31, 2020 1, Geert Uytterhoeven wrote:
> However, the documentation for "SCIFA" on RZ/A2 (for which we use
> PORT_SCIF, not PORT_SCIFA, in the driver) has conflicting information:
> 1. Section 17.2.7 "Serial Status Register (FSR)" says:
> - A receive framing/parity error occurred in the "next receive
> data read" from the FIFO,
> - Indicates whether there is a framing/parity error in the data
> "read" from the FIFO.
> 2. Figure 17.8 "Sample Flowchart for Receiving Serial Data in
> Asynchronous Mode (2)".
> - Whether a framing error or parity error has occurred in the
> received data that is "read" from the FIFO.
>
> So while the change looks OK for most Renesas ARM SoCs, the situation
> for RZ/A2 is unclear.
> Note that the above does not take into account variants used on SuperH
> SoCs.

For the RZ/A2M, it is NOT a "SCIFA"...even though it says that in the
hardware manual.

And honestly, I could not trace back where that IP came from. It was
from somewhere in the MCU design section (not the SoC design section).
Someone modified the IP so they put an "A" at the end to show it was
different. Regardless, it has a different history than all the other IP
supported by the SCI driver.

Chris

\
 
 \ /
  Last update: 2020-03-31 21:08    [W:0.110 / U:4.168 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site