[lkml]   [2020]   [Mar]   [11]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
Messages in this thread
Subject[PATCH 0/6] Add DT bindings for USB HS/SS in QCS404
This set adds DT entries for the Primary and Secondary DWC3 controllers on
QCS404 and the PHYs attached to those controllers.

Additional board-specific bindings are required to make the SoC change
functional on the EVBs as on the EVB a type-c connector interfaces with the
SoC which is responsible to toggle VBUS via a regulator interface directly.

These patches have been through seven review cycles already and have a
number of Review-by and Ack-by. For the pusposes of making it easier to
merge this set focuses on the SoC DT bindings and target board bindings

The last set for can be found here:

Bjorn Andersson (1):
arm64: dts: qcom: qcs404: Add USB devices and PHYs

Bryan O'Donoghue (5):
arm64: dts: qcom: qcs404-evb: Define VBUS pins
arm64: dts: qcom: qcs404-evb: Define USB ID pin
arm64: dts: qcom: qcs404-evb: Describe external VBUS regulator
arm64: dts: qcom: qcs404-evb: Raise vreg_l12_3p3 minimum voltage
arm64: dts: qcom: qcs404-evb: Enable USB controllers

arch/arm64/boot/dts/qcom/qcs404-evb.dtsi | 90 +++++++++++++++++++-
arch/arm64/boot/dts/qcom/qcs404.dtsi | 100 +++++++++++++++++++++++
2 files changed, 189 insertions(+), 1 deletion(-)


 \ /
  Last update: 2020-03-11 20:16    [W:0.066 / U:2.176 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site