[lkml]   [2020]   [Feb]   [15]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
Messages in this thread
SubjectRe: [PATCH v2] mtd: mtk-quadspi: add support for DMA reading
Hi all!

On Sat, Feb 8, 2020 at 4:41 PM Chuanhong Guo <> wrote:
> PIO reading mode on this controller is pretty inefficient
> (one cmd+addr+dummy sequence reads only one byte)
> This patch adds support for reading using DMA mode which increases
> reading speed from 1MB/s to 4MB/s
> DMA busy checking is implemented with readl_poll_timeout because
> I don't have access to IRQ-related docs. The speed increment comes
> from those saved cmd+addr+dummy clocks.
> This controller requires that DMA source/destination address and
> reading length should be 16-byte aligned. We use a bounce buffer if
> one of them is not aligned, read more than what we need, and copy
> data from corresponding buffer offset.
> Signed-off-by: Chuanhong Guo <>

This patch is deprecated. I wrote a new spi-mem driver for this
and will be focus on getting that one merged instead.
Chuanhong Guo

 \ /
  Last update: 2020-02-15 08:07    [W:0.070 / U:3.672 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site