[lkml]   [2020]   [Feb]   [12]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
Messages in this thread
SubjectRe: [PATCH v3 6/6] ASoC: qdsp6: dt-bindings: Add q6afe pcm dt binding documentation
On 2020-02-12 06:43, Srinivas Kandagatla wrote:
> On 12/02/2020 11:01, Adam Serbinski wrote:
>>>> +
>>>> + - qcom,pcm-slot-mapping
>>>> +    Usage: required for pcm interface
>>> Are these not specific to 8k and 16k mode ?
>>> We should probably list values for both modes here.
>> No, this is just the offset that the audio sample is placed in with
>> respect to a maximum of 4 slots, 16 bits wide, beginning with the sync
>> pulse.
> That's not true atleast by the QDSP documentation,
> according to it we will use more slots to transfer at higher sample
> rate. ex:
> 16 kHz data can be transferred using 8 kHz samples in two
> slots.
> Also there are 32 slots for each of 4 supported channels for PCM AFE
> port.

Ok, if that's the case, then it sounds like someone else is going to
have to implement it. I have no way to test that kind of a
configuration, so attempting to implement it would be futile.

>> When switching between 8 and 16k sample rate, it is just the sync
>> pulse rate that is changed. The audio sample will be delivered in the
>> same slot, just at a different frequency.

 \ /
  Last update: 2020-02-12 13:08    [W:0.061 / U:1.372 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site