[lkml]   [2020]   [Nov]   [7]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
Messages in this thread
Patch in this message
Subject[PATCH v2] clk: exynos7: Keep aclk_fsys1_200 enabled
This clock must be always enabled to allow access to any registers in
fsys1 CMU. Until proper solution based on runtime PM is applied
(similar to what was done for Exynos5433), fix this by calling
clk_prepare_enable() directly from clock provider driver.

It was observed on Samsung Galaxy S6 device (based on Exynos7420), where
UFS module is probed before pmic used to power that device.
In this case defer probe was happening and that clock was disabled by
UFS driver, causing whole boot to hang on next CMU access.

Signed-off-by: Paweł Chmiel <>
Changes from v1:
- Instead of marking clock as critical, enable it manually in driver.
drivers/clk/samsung/clk-exynos7.c | 5 +++++
1 file changed, 5 insertions(+)

diff --git a/drivers/clk/samsung/clk-exynos7.c b/drivers/clk/samsung/clk-exynos7.c
index c1ff715e960c..e05b673e277f 100644
--- a/drivers/clk/samsung/clk-exynos7.c
+++ b/drivers/clk/samsung/clk-exynos7.c
@@ -6,6 +6,7 @@

#include <linux/clk-provider.h>
#include <linux/of.h>
+#include <linux/clk.h>

#include "clk.h"
#include <dt-bindings/clock/exynos7-clk.h>
@@ -571,6 +572,10 @@ static const struct samsung_cmu_info top1_cmu_info __initconst = {
static void __init exynos7_clk_top1_init(struct device_node *np)
samsung_cmu_register_one(np, &top1_cmu_info);
+ /*
+ * Keep top FSYS1 aclk enabled permanently. It's required for CMU register access.
+ */
+ clk_prepare_enable(__clk_lookup("aclk_fsys1_200"));

CLK_OF_DECLARE(exynos7_clk_top1, "samsung,exynos7-clock-top1",
 \ /
  Last update: 2020-11-07 13:15    [W:0.053 / U:0.888 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site