lkml.org 
[lkml]   [2020]   [Nov]   [18]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
From
Date
SubjectRe: [PATCH V4 2/5] arm64: dts: imx8mn: Enable Asynchronous Sample Rate Converter
On Sat, Nov 7, 2020 at 5:58 AM Adam Ford <aford173@gmail.com> wrote:
>
> The driver exists for the Enhanced Asynchronous Sample Rate Converter
> (EASRC) Controller, but there isn't a device tree entry for it.
>
> On the vendor kernel, they put this on a spba-bus for SDMA support.
>
> Add the node for the spba-bus with the easrc node inside.
>
> Signed-off-by: Adam Ford <aford173@gmail.com>

Shawn,

I split the dt-binding into a separate patch since I was struggling
with checking the yaml syntax. Rob helped me find the proper branch
to use. I hope it goes through this time.

Do you have any comments on the rest of the series? I would like to
fix them if you have any concerns so I can resend if/when the
dt-binding is accepted.

thanks,

adam

> ---
> V4: No change
> V3: Change spba-bus@30000000 to spba: bus@30000000
> V2: Make the DT node more in-line with the dt binding and remove
> vendor customizations that are not applicable.
> arch/arm64/boot/dts/freescale/imx8mn.dtsi | 28 +++++++++++++++++++++++
> 1 file changed, 28 insertions(+)
>
> diff --git a/arch/arm64/boot/dts/freescale/imx8mn.dtsi b/arch/arm64/boot/dts/freescale/imx8mn.dtsi
> index a06d2a6268e6..61560c083300 100644
> --- a/arch/arm64/boot/dts/freescale/imx8mn.dtsi
> +++ b/arch/arm64/boot/dts/freescale/imx8mn.dtsi
> @@ -253,6 +253,34 @@ aips1: bus@30000000 {
> #size-cells = <1>;
> ranges;
>
> + spba: bus@30000000 {
> + compatible = "fsl,spba-bus", "simple-bus";
> + #address-cells = <1>;
> + #size-cells = <1>;
> + reg = <0x30000000 0x100000>;
> + ranges;
> +
> + easrc: easrc@300c0000 {
> + compatible = "fsl,imx8mn-easrc";
> + reg = <0x300c0000 0x10000>;
> + interrupts = <GIC_SPI 122 IRQ_TYPE_LEVEL_HIGH>;
> + clocks = <&clk IMX8MN_CLK_ASRC_ROOT>;
> + clock-names = "mem";
> + dmas = <&sdma2 16 23 0> , <&sdma2 17 23 0>,
> + <&sdma2 18 23 0> , <&sdma2 19 23 0>,
> + <&sdma2 20 23 0> , <&sdma2 21 23 0>,
> + <&sdma2 22 23 0> , <&sdma2 23 23 0>;
> + dma-names = "ctx0_rx", "ctx0_tx",
> + "ctx1_rx", "ctx1_tx",
> + "ctx2_rx", "ctx2_tx",
> + "ctx3_rx", "ctx3_tx";
> + firmware-name = "imx/easrc/easrc-imx8mn.bin";
> + fsl,asrc-rate = <8000>;
> + fsl,asrc-format = <2>;
> + status = "disabled";
> + };
> + };
> +
> gpio1: gpio@30200000 {
> compatible = "fsl,imx8mn-gpio", "fsl,imx35-gpio";
> reg = <0x30200000 0x10000>;
> --
> 2.25.1
>

\
 
 \ /
  Last update: 2020-11-19 00:16    [W:0.080 / U:8.684 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site