lkml.org 
[lkml]   [2020]   [Oct]   [2]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
From
SubjectRe: [PATCH v2 0/5] usb: dwc-meson-g12a: Add support for USB on S400 board
Date
Neil Armstrong <narmstrong@baylibre.com> writes:

> Hi Kevin,
>
> On 17/09/2020 08:59, Neil Armstrong wrote:
>> The Amlogic AXG is close to the GXL Glue but with a single OTG PHY.
>>
>> It needs the same init sequence as GXL & GXM, but it seems it doesn't need
>> the host disconnect bit.
>>
>> The Glue driver reuses the already implemented GXL & GXM work.
>>
>> The USB2 PHY driver needs a slight tweak to keep the OTG detection working.
>>
>> Changes since v1 at [1]:
>> - s/close from/close to/g
>> - collected review tags
>> - added small comment about phy management in patch 3
>> - removed status = "okay" in patch 4
>> - removed invalid phy-supply of phy1 in patch 5
>>
>> [1] http://lore.kernel.org/r/20200909160409.8678-1-narmstrong@baylibre.com
>>
>> Neil Armstrong (5):
>> phy: amlogic: phy-meson-gxl-usb2: keep ID pull-up even in Host mode
>> dt-bindings: usb: amlogic,meson-g12a-usb-ctrl: add the Amlogic AXG
>> Families USB Glue Bindings
>> usb: dwc-meson-g12a: Add support for USB on AXG SoCs
>> arm64: dts: meson-axg: add USB nodes
>> arm64: dts: meson-axg-s400: enable USB OTG
>
> Can you pick the DT patches ?

Yes, queued up.

Since we're already at -rc7, this may not make it until v5.11.

Kevin

\
 
 \ /
  Last update: 2020-10-02 20:24    [W:0.362 / U:27.156 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site