[lkml]   [2020]   [Oct]   [2]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
Messages in this thread
SubjectRe: [PATCH 0/8] Add support for UHS modes in TI's J721e and J7200 boards
Hi Nishanth,

On 02/10/20 12:43 am, Nishanth Menon wrote:
> On 00:35-20201002, Faiz Abbas wrote:
>> The following patches add support for UHS modes for TI's j721e and j7200
>> boards.
>> Patches 1-3 add support for gpios to j7200-evm
>> Patches 4-6 add support for voltage regulators for required by the
>> SD card in both devices as well as enable UHS modes at 1.8V
>> Patches 5-6 add some required configs to the arm64 defconfig.
>> This series depends on driver patches adding tuning support here:
>> Faiz Abbas (8):
>> arm64: dts: ti: k3-j7200-main: Add gpio nodes in main domain
>> arm64: dts: ti: k3-j7200: Add gpio nodes in wakeup domain
>> arm64: dts: ti: k3-j7200-common-proc-board: Disable unused gpio
>> modules
>> arm64: dts: ti: k3-j721e-main: Add output tap delay values
>> arm64: dts: ti: k3-j721e-common-proc-board: Add support SD card UHS
>> modes
>> arm64: dts: ti: k3-j7200-common-proc-board: Add support SD card UHS
>> modes
> Split these up please!

Into SD card UHS and gpio series?

>> arm64: defconfig: Enable OMAP I2C driver
>> arm64: defconfig: Enable DAVINCI_GPIO driver
> defconfig patches can be posted independent of dts patches, they go to
> different branches.

I was trying to follow Arnd's advice here:

He says that defconfig patches can be sent at the same time as dts updates and maintainers can send those
as separate pull requests.


 \ /
  Last update: 2020-10-02 06:45    [W:0.108 / U:10.824 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site