lkml.org 
[lkml]   [2020]   [Jan]   [9]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
Date
From
SubjectRe: [PATCH v2 2/6] i2c: at91: implement i2c bus recovery
On Fri, Jan 03, 2020 at 09:49:07AM +0000, Codrin Ciubotariu - M19940 wrote:
> From: Kamel Bouhara <kamel.bouhara@bootlin.com>
>
> Implement i2c bus recovery when slaves devices might hold SDA low.
> In this case re-assign SCL/SDA to gpios and issue 9 dummy clock pulses
> until the slave release SDA.
>
> Signed-off-by: Kamel Bouhara <kamel.bouhara@bootlin.com>
> [codrin.ciubotariu@microchip.com: release gpios on error; move i2c_recover_bus]
> Signed-off-by: Codrin Ciubotariu <codrin.ciubotariu@microchip.com>
> ---
>
> Changes in v2:
> - called i2c_recover_bus() after an error occurs, if SDA is down;
> - release gpios if recovery information is incomplete;
>
> drivers/i2c/busses/i2c-at91-master.c | 79 ++++++++++++++++++++++++++++
> drivers/i2c/busses/i2c-at91.h | 8 +++
> 2 files changed, 87 insertions(+)
>
> diff --git a/drivers/i2c/busses/i2c-at91-master.c b/drivers/i2c/busses/i2c-at91-master.c
> index 7a862e00b475..c55e8ff35201 100644
> --- a/drivers/i2c/busses/i2c-at91-master.c
> +++ b/drivers/i2c/busses/i2c-at91-master.c
> @@ -18,11 +18,13 @@
> #include <linux/dma-mapping.h>
> #include <linux/dmaengine.h>
> #include <linux/err.h>
> +#include <linux/gpio/consumer.h>
> #include <linux/i2c.h>
> #include <linux/interrupt.h>
> #include <linux/io.h>
> #include <linux/of.h>
> #include <linux/of_device.h>
> +#include <linux/pinctrl/consumer.h>
> #include <linux/platform_device.h>
> #include <linux/platform_data/dma-atmel.h>
> #include <linux/pm_runtime.h>
> @@ -478,6 +480,7 @@ static int at91_do_twi_transfer(struct at91_twi_dev *dev)
> unsigned long time_left;
> bool has_unre_flag = dev->pdata->has_unre_flag;
> bool has_alt_cmd = dev->pdata->has_alt_cmd;
> + struct i2c_bus_recovery_info *rinfo = &dev->rinfo;
>
> /*
> * WARNING: the TXCOMP bit in the Status Register is NOT a clear on
> @@ -637,6 +640,13 @@ static int at91_do_twi_transfer(struct at91_twi_dev *dev)
> at91_twi_write(dev, AT91_TWI_CR,
> AT91_TWI_THRCLR | AT91_TWI_LOCKCLR);
> }
> +
> + if (rinfo->get_sda && !(rinfo->get_sda(&dev->adapter))) {
> + dev_dbg(dev->dev,
> + "SDA is down; clear bus using gpio\n");
> + i2c_recover_bus(&dev->adapter);
> + }
> +
> return ret;
> }
>
> @@ -806,6 +816,71 @@ static int at91_twi_configure_dma(struct at91_twi_dev *dev, u32 phy_addr)
> return ret;
> }
>
> +static void at91_prepare_twi_recovery(struct i2c_adapter *adap)
> +{
> + struct at91_twi_dev *dev = i2c_get_adapdata(adap);
> +
> + pinctrl_select_state(dev->pinctrl, dev->pinctrl_pins_gpio);
> +}
> +
> +static void at91_unprepare_twi_recovery(struct i2c_adapter *adap)
> +{
> + struct at91_twi_dev *dev = i2c_get_adapdata(adap);
> +
> + pinctrl_select_state(dev->pinctrl, dev->pinctrl_pins_default);
> +}
> +
> +static int at91_init_twi_recovery_info(struct platform_device *pdev,
> + struct at91_twi_dev *dev)
> +{
> + struct i2c_bus_recovery_info *rinfo = &dev->rinfo;
> +
> + dev->pinctrl = devm_pinctrl_get(&pdev->dev);
> + if (!dev->pinctrl || IS_ERR(dev->pinctrl)) {
> + dev_info(dev->dev, "can't get pinctrl, bus recovery not supported\n");
> + return PTR_ERR(dev->pinctrl);
> + }
> +
> + dev->pinctrl_pins_default = pinctrl_lookup_state(dev->pinctrl,
> + PINCTRL_STATE_DEFAULT);
> + dev->pinctrl_pins_gpio = pinctrl_lookup_state(dev->pinctrl,
> + "gpio");
> + rinfo->sda_gpiod = devm_gpiod_get(&pdev->dev, "sda", GPIOD_IN);
> + if (PTR_ERR(rinfo->sda_gpiod) == -EPROBE_DEFER)
> + return -EPROBE_DEFER;
> +
> + rinfo->scl_gpiod = devm_gpiod_get(&pdev->dev, "scl",
> + GPIOD_OUT_HIGH_OPEN_DRAIN);
> + if (PTR_ERR(rinfo->scl_gpiod) == -EPROBE_DEFER)
> + return -EPROBE_DEFER;
> +
> + if (IS_ERR(rinfo->sda_gpiod) ||
> + IS_ERR(rinfo->scl_gpiod) ||
> + IS_ERR(dev->pinctrl_pins_default) ||
> + IS_ERR(dev->pinctrl_pins_gpio)) {
> + dev_info(&pdev->dev, "recovery information incomplete\n");
> + if (!IS_ERR(rinfo->sda_gpiod)) {
> + gpiod_put(rinfo->sda_gpiod);
> + rinfo->sda_gpiod = NULL;
> + }
> + if (!IS_ERR(rinfo->scl_gpiod)) {
> + gpiod_put(rinfo->scl_gpiod);
> + rinfo->scl_gpiod = NULL;
> + }
> + return -EINVAL;
> + }
> +
> + dev_info(&pdev->dev, "using scl%s for recovery\n",
> + rinfo->sda_gpiod ? ",sda" : "");

Is it possible to have scl without sda? From the condition before, if
there is an error for sda or scl, an error is returned.

> +
> + rinfo->prepare_recovery = at91_prepare_twi_recovery;
> + rinfo->unprepare_recovery = at91_unprepare_twi_recovery;
> + rinfo->recover_bus = i2c_generic_scl_recovery;
> + dev->adapter.bus_recovery_info = rinfo;
> +
> + return 0;
> +}
> +
> int at91_twi_probe_master(struct platform_device *pdev,
> u32 phy_addr, struct at91_twi_dev *dev)
> {
> @@ -838,6 +913,10 @@ int at91_twi_probe_master(struct platform_device *pdev,
> "i2c-analog-filter");
> at91_calc_twi_clock(dev);
>
> + rc = at91_init_twi_recovery_info(pdev, dev);
> + if (rc == -EPROBE_DEFER)
> + return rc;
> +
> dev->adapter.algo = &at91_twi_algorithm;
> dev->adapter.quirks = &at91_twi_quirks;
>
> diff --git a/drivers/i2c/busses/i2c-at91.h b/drivers/i2c/busses/i2c-at91.h
> index 977a67bc0f88..eb335b71e775 100644
> --- a/drivers/i2c/busses/i2c-at91.h
> +++ b/drivers/i2c/busses/i2c-at91.h
> @@ -151,6 +151,10 @@ struct at91_twi_dev {
> u32 fifo_size;
> struct at91_twi_dma dma;
> bool slave_detected;
> + struct i2c_bus_recovery_info rinfo;
> + struct pinctrl *pinctrl;
> + struct pinctrl_state *pinctrl_pins_default;
> + struct pinctrl_state *pinctrl_pins_gpio;
> #ifdef CONFIG_I2C_AT91_SLAVE_EXPERIMENTAL
> unsigned smr;
> struct i2c_client *slave;
> @@ -171,6 +175,10 @@ void at91_init_twi_bus_master(struct at91_twi_dev *dev);
> int at91_twi_probe_master(struct platform_device *pdev, u32 phy_addr,
> struct at91_twi_dev *dev);
>

Wrong names here:

> +void at91_twi_prepare_recovery(struct i2c_adapter *adap);
at91_prepare_twi_recovery

> +void at91_twi_unprepare_recovery(struct i2c_adapter *adap);
at91_unprepare_twi_recovery

> +void at91_twi_init_recovery_info(struct at91_twi_dev *dev);
at91_init_twi_recovery_info

Are these declarations still needed?

Ludovic
> +
> #ifdef CONFIG_I2C_AT91_SLAVE_EXPERIMENTAL
> void at91_init_twi_bus_slave(struct at91_twi_dev *dev);
> int at91_twi_probe_slave(struct platform_device *pdev, u32 phy_addr,
> --
> 2.20.1

\
 
 \ /
  Last update: 2020-01-09 08:49    [W:0.502 / U:0.012 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site