Messages in this thread |  | | Subject | Re: [PATCH v6 00/19] Move PMC clocks into Tegra PMC driver | From | Sowjanya Komatineni <> | Date | Tue, 7 Jan 2020 15:24:16 -0800 |
| |
On 1/7/20 3:01 PM, Dmitry Osipenko wrote: > Hello Sowjanya, > > 07.01.2020 07:13, Sowjanya Komatineni пишет: >> This patch series moves Tegra PMC clocks from clock driver to pmc driver >> along with the device trees changes and audio driver which uses one of >> the pmc clock for audio mclk. >> >> Tegra PMC has clk_out_1, clk_out_2, clk_out_3 and blink controls which >> are currently registered by Tegra clock driver using clk_regiser_mux and >> clk_register_gate which performs direct Tegra PMC register access. >> >> When Tegra PMC is in secure mode, any access from non-secure world will >> not go through. >> >> This patch series adds these Tegra PMC clocks and blink controls to Tegra >> PMC driver with PMC as clock provider and removes them from Tegra clock >> driver. >> >> PMC clock clk_out_1 is dedicated for audio mclk from Tegra30 thru Tegra210 >> and clock driver does inital parent configuration for it and enables them. >> But this clock should be taken care by audio driver as there is no need >> to have this clock pre enabled. >> >> So, this series also includes patch that updates ASoC driver to take >> care of parent configuration for mclk if device tree don't specify >> initial parent configuration using assigned-clock-parents and controls >> audio mclk enable/disable during ASoC machine startup and shutdown. >> >> DTs are also updated to use clk_out_1 as audio mclk rather than extern1. >> >> This series also includes a patch for mclk fallback to extern1 when >> retrieving mclk fails to have this backward compatible of new DT with >> old kernels. >> >> [v6]: Changes between v5 and v6 are >> - v5 feedback >> - Added ASoC machine startup and shutdown callbacks to control audio >> mclk enable/disable and removed default mclk enable from clock driver. >> - Updated tegra_asoc_utils_set_rate to disable mclk only during PLLA >> rate change and removed disabling PLLA as its already taken care by >> pll clock driver. >> - Removed tegra_asoc_utils_set_rate call from utils_init as set_rate >> is set during machine hw_params and during utils_init mclk is >> already in disabled state and this causes warning during mclk disable >> in utils_set_rate. >> >> [v5]: Changes between v4 and v5 are >> - v4 feedback >> - updated dt-binding pmc YAML schema with more description on power >> gate nodes and pad configuration state nodes. >> - update tegra_asoc_utils_set_rate to disable audio mclk only if >> its in enable state. >> >> [v4]: Changes between v3 and v4 are >> - v3 Feedback >> - Updated clocks clk_m_div2 and clk_m_div4 as osc_div2 and osc_div4. >> Tegra don't have clk_m_div2, clk_m_div4 and they should actually >> be osc_div2 and osc_div4 clocks from osc pads. >> - Fixed PMC clock parents to use osc, osc_div2, osc_div4. >> - Register each PMC clock as single clock rather than separate >> mux and gate clocks. >> - Update ASoC utils to use resource managed APIs rather than >> using clk_get and clk_put. >> - Updated device tree and ASoC driver to use clk_out_1 instead of >> clk_out_1_mux as PMC clocks are registered as single clock. >> - Update clock driver init_table to not enable audio related clocks >> as ASoC utils will do audio clock enables. >> >> [v3]: Changes between v2 and v3 are >> - Removes set parent of clk_out_1_mux to extern1 and enabling >> extern1 from the clock driver. >> - Doesn't enable clk_out_1 and blink by default in pmc driver >> - Updates ASoC driver to take care of audio mclk parent >> configuration incase if device tree don't specify assigned >> clock parent properties and enables mclk using both clk_out_1 >> and extern1. >> - updates all device trees using extern1 as mclk in sound node >> to use clk_out_1 from pmc. >> - patch for YAML format pmc dt-binding >> - Includes v2 feedback >> >> [v2]: Changes between v1 and v2 are >> - v2 includes patches for adding clk_out_1, clk_out_2, clk_out_3, >> blink controls to Tegra PMC driver and removing clk-tegra-pmc. >> - feedback related to pmc clocks in Tegra PMC driver from v1 >> - Removed patches for WB0 PLLM overrides and PLLE IDDQ PMC programming >> by the clock driver using helper functions from Tegra PMC. >> >> Note: >> To use helper functions from PMC driver, PMC early init need to >> happen prior to using helper functions and these helper functions are >> for PLLM Override and PLLE IDDQ programming in PMC during PLLM/PLLE >> clock registration which happen in clock_init prior to Tegra PMC >> probe. >> Moving PLLM/PLLE clocks registration to happen after Tegra PMC >> impacts other clocks EMC, MC and corresponding tegra_emc_init and >> tegra_mc_init. >> This implementation of configuring PMC registers thru helper >> functions in clock driver needs proper changes across PMC, Clock, >> EMC and MC inits to have it work across all Tegra platforms. >> >> Currently PLLM Override is not enabled in the bootloader so proper >> patches for this fix will be taken care separately. >> >> [v1]: v1 includes patches for below fixes. >> - adding clk_out_1, clk_out_2, clk_out_3, blink controls to Tegra PMC >> driver and removing clk-tegra-pmc. >> - updated clock provider from tegra_car to pmc in the device tree >> tegra210-smaug.dts that uses clk_out_2. >> - Added helper functions in PMC driver for WB0 PLLM overrides and PLLE >> IDDQ programming to use by clock driver and updated clock driver to >> use these helper functions and removed direct PMC access from clock >> driver and all pmc base address references in clock driver. >> >> >> >> >> Sowjanya Komatineni (19): >> dt-bindings: clock: tegra: Change CLK_M_DIV to OSC_DIV clocks >> clk: tegra: Change CLK_M_DIV clocks to OSC_DIV clocks >> clk: tegra: Fix Tegra PMC clock out parents >> dt-bindings: tegra: Convert Tegra PMC bindings to YAML >> dt-bindings: soc: tegra-pmc: Add Tegra PMC clock bindings >> soc: tegra: Add Tegra PMC clocks registration into PMC driver >> dt-bindings: soc: tegra-pmc: Add id for Tegra PMC 32KHz blink clock >> soc: tegra: Add support for 32KHz blink clock >> clk: tegra: Remove tegra_pmc_clk_init along with clk ids >> dt-bindings: clock: tegra: Remove pmc clock ids from clock dt-bindings >> ASoC: tegra: Use device managed resource APIs to get the clock >> ASoC: tegra: Add audio mclk configuration >> ASoC: tegra: Add fallback implementation for audio mclk >> clk: tegra: Remove audio related clock enables from init_table >> ARM: dts: tegra: Add clock-cells property to pmc >> arm64: tegra: Add clock-cells property to Tegra PMC node >> ARM: tegra: Update sound node clocks in device tree >> arm64: tegra: smaug: Change clk_out_2 provider to pmc >> ASoC: nau8825: change Tegra clk_out_2 provider from tegra_car to pmc >> >> .../bindings/arm/tegra/nvidia,tegra20-pmc.txt | 300 ----------------- >> .../bindings/arm/tegra/nvidia,tegra20-pmc.yaml | 354 +++++++++++++++++++++ >> .../devicetree/bindings/sound/nau8825.txt | 2 +- >> arch/arm/boot/dts/tegra114-dalmore.dts | 8 +- >> arch/arm/boot/dts/tegra114.dtsi | 4 +- >> arch/arm/boot/dts/tegra124-apalis-v1.2.dtsi | 8 +- >> arch/arm/boot/dts/tegra124-apalis.dtsi | 8 +- >> arch/arm/boot/dts/tegra124-jetson-tk1.dts | 8 +- >> arch/arm/boot/dts/tegra124-nyan.dtsi | 8 +- >> arch/arm/boot/dts/tegra124-venice2.dts | 8 +- >> arch/arm/boot/dts/tegra124.dtsi | 4 +- >> arch/arm/boot/dts/tegra20.dtsi | 4 +- >> arch/arm/boot/dts/tegra30-apalis-v1.1.dtsi | 8 +- >> arch/arm/boot/dts/tegra30-apalis.dtsi | 8 +- >> arch/arm/boot/dts/tegra30-beaver.dts | 8 +- >> arch/arm/boot/dts/tegra30-cardhu.dtsi | 8 +- >> arch/arm/boot/dts/tegra30-colibri.dtsi | 8 +- >> arch/arm/boot/dts/tegra30.dtsi | 4 +- >> arch/arm64/boot/dts/nvidia/tegra132.dtsi | 4 +- >> arch/arm64/boot/dts/nvidia/tegra210-smaug.dts | 2 +- >> arch/arm64/boot/dts/nvidia/tegra210.dtsi | 6 +- >> drivers/clk/tegra/Makefile | 1 - >> drivers/clk/tegra/clk-id.h | 11 +- >> drivers/clk/tegra/clk-tegra-fixed.c | 32 +- >> drivers/clk/tegra/clk-tegra-pmc.c | 122 ------- >> drivers/clk/tegra/clk-tegra114.c | 41 +-- >> drivers/clk/tegra/clk-tegra124.c | 46 +-- >> drivers/clk/tegra/clk-tegra20.c | 9 +- >> drivers/clk/tegra/clk-tegra210.c | 30 +- >> drivers/clk/tegra/clk-tegra30.c | 31 +- >> drivers/clk/tegra/clk.h | 1 - >> drivers/soc/tegra/pmc.c | 352 ++++++++++++++++++++ >> include/dt-bindings/clock/tegra114-car.h | 18 +- >> include/dt-bindings/clock/tegra124-car-common.h | 18 +- >> include/dt-bindings/clock/tegra20-car.h | 2 +- >> include/dt-bindings/clock/tegra210-car.h | 18 +- >> include/dt-bindings/clock/tegra30-car.h | 18 +- >> include/dt-bindings/soc/tegra-pmc.h | 16 + >> sound/soc/tegra/tegra_alc5632.c | 28 +- >> sound/soc/tegra/tegra_asoc_utils.c | 125 ++++---- >> sound/soc/tegra/tegra_asoc_utils.h | 3 +- >> sound/soc/tegra/tegra_max98090.c | 43 ++- >> sound/soc/tegra/tegra_rt5640.c | 43 ++- >> sound/soc/tegra/tegra_rt5677.c | 28 +- >> sound/soc/tegra/tegra_sgtl5000.c | 28 +- >> sound/soc/tegra/tegra_wm8753.c | 43 ++- >> sound/soc/tegra/tegra_wm8903.c | 43 ++- >> sound/soc/tegra/tegra_wm9712.c | 8 +- >> sound/soc/tegra/trimslice.c | 39 ++- >> 49 files changed, 1192 insertions(+), 777 deletions(-) >> delete mode 100644 Documentation/devicetree/bindings/arm/tegra/nvidia,tegra20-pmc.txt >> create mode 100644 Documentation/devicetree/bindings/arm/tegra/nvidia,tegra20-pmc.yaml >> delete mode 100644 drivers/clk/tegra/clk-tegra-pmc.c >> create mode 100644 include/dt-bindings/soc/tegra-pmc.h >> > I briefly looked through the patches and tested them in all possible > configurations. For now everything looks and works well. > > You could add this to all patches: > > Tested-by: Dmitry Osipenko <digetx@gmail.com> > Reviewed-by: Dmitry Osipenko <digetx@gmail.com> Thanks Dmitry
|  |