lkml.org 
[lkml]   [2020]   [Jan]   [7]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
SubjectRe: [PATCH v6 00/19] Move PMC clocks into Tegra PMC driver
From
Date
Hello Sowjanya,

07.01.2020 07:13, Sowjanya Komatineni пишет:
> This patch series moves Tegra PMC clocks from clock driver to pmc driver
> along with the device trees changes and audio driver which uses one of
> the pmc clock for audio mclk.
>
> Tegra PMC has clk_out_1, clk_out_2, clk_out_3 and blink controls which
> are currently registered by Tegra clock driver using clk_regiser_mux and
> clk_register_gate which performs direct Tegra PMC register access.
>
> When Tegra PMC is in secure mode, any access from non-secure world will
> not go through.
>
> This patch series adds these Tegra PMC clocks and blink controls to Tegra
> PMC driver with PMC as clock provider and removes them from Tegra clock
> driver.
>
> PMC clock clk_out_1 is dedicated for audio mclk from Tegra30 thru Tegra210
> and clock driver does inital parent configuration for it and enables them.
> But this clock should be taken care by audio driver as there is no need
> to have this clock pre enabled.
>
> So, this series also includes patch that updates ASoC driver to take
> care of parent configuration for mclk if device tree don't specify
> initial parent configuration using assigned-clock-parents and controls
> audio mclk enable/disable during ASoC machine startup and shutdown.
>
> DTs are also updated to use clk_out_1 as audio mclk rather than extern1.
>
> This series also includes a patch for mclk fallback to extern1 when
> retrieving mclk fails to have this backward compatible of new DT with
> old kernels.
>
> [v6]: Changes between v5 and v6 are
> - v5 feedback
> - Added ASoC machine startup and shutdown callbacks to control audio
> mclk enable/disable and removed default mclk enable from clock driver.
> - Updated tegra_asoc_utils_set_rate to disable mclk only during PLLA
> rate change and removed disabling PLLA as its already taken care by
> pll clock driver.
> - Removed tegra_asoc_utils_set_rate call from utils_init as set_rate
> is set during machine hw_params and during utils_init mclk is
> already in disabled state and this causes warning during mclk disable
> in utils_set_rate.
>
> [v5]: Changes between v4 and v5 are
> - v4 feedback
> - updated dt-binding pmc YAML schema with more description on power
> gate nodes and pad configuration state nodes.
> - update tegra_asoc_utils_set_rate to disable audio mclk only if
> its in enable state.
>
> [v4]: Changes between v3 and v4 are
> - v3 Feedback
> - Updated clocks clk_m_div2 and clk_m_div4 as osc_div2 and osc_div4.
> Tegra don't have clk_m_div2, clk_m_div4 and they should actually
> be osc_div2 and osc_div4 clocks from osc pads.
> - Fixed PMC clock parents to use osc, osc_div2, osc_div4.
> - Register each PMC clock as single clock rather than separate
> mux and gate clocks.
> - Update ASoC utils to use resource managed APIs rather than
> using clk_get and clk_put.
> - Updated device tree and ASoC driver to use clk_out_1 instead of
> clk_out_1_mux as PMC clocks are registered as single clock.
> - Update clock driver init_table to not enable audio related clocks
> as ASoC utils will do audio clock enables.
>
> [v3]: Changes between v2 and v3 are
> - Removes set parent of clk_out_1_mux to extern1 and enabling
> extern1 from the clock driver.
> - Doesn't enable clk_out_1 and blink by default in pmc driver
> - Updates ASoC driver to take care of audio mclk parent
> configuration incase if device tree don't specify assigned
> clock parent properties and enables mclk using both clk_out_1
> and extern1.
> - updates all device trees using extern1 as mclk in sound node
> to use clk_out_1 from pmc.
> - patch for YAML format pmc dt-binding
> - Includes v2 feedback
>
> [v2]: Changes between v1 and v2 are
> - v2 includes patches for adding clk_out_1, clk_out_2, clk_out_3,
> blink controls to Tegra PMC driver and removing clk-tegra-pmc.
> - feedback related to pmc clocks in Tegra PMC driver from v1
> - Removed patches for WB0 PLLM overrides and PLLE IDDQ PMC programming
> by the clock driver using helper functions from Tegra PMC.
>
> Note:
> To use helper functions from PMC driver, PMC early init need to
> happen prior to using helper functions and these helper functions are
> for PLLM Override and PLLE IDDQ programming in PMC during PLLM/PLLE
> clock registration which happen in clock_init prior to Tegra PMC
> probe.
> Moving PLLM/PLLE clocks registration to happen after Tegra PMC
> impacts other clocks EMC, MC and corresponding tegra_emc_init and
> tegra_mc_init.
> This implementation of configuring PMC registers thru helper
> functions in clock driver needs proper changes across PMC, Clock,
> EMC and MC inits to have it work across all Tegra platforms.
>
> Currently PLLM Override is not enabled in the bootloader so proper
> patches for this fix will be taken care separately.
>
> [v1]: v1 includes patches for below fixes.
> - adding clk_out_1, clk_out_2, clk_out_3, blink controls to Tegra PMC
> driver and removing clk-tegra-pmc.
> - updated clock provider from tegra_car to pmc in the device tree
> tegra210-smaug.dts that uses clk_out_2.
> - Added helper functions in PMC driver for WB0 PLLM overrides and PLLE
> IDDQ programming to use by clock driver and updated clock driver to
> use these helper functions and removed direct PMC access from clock
> driver and all pmc base address references in clock driver.
>
>
>
>
> Sowjanya Komatineni (19):
> dt-bindings: clock: tegra: Change CLK_M_DIV to OSC_DIV clocks
> clk: tegra: Change CLK_M_DIV clocks to OSC_DIV clocks
> clk: tegra: Fix Tegra PMC clock out parents
> dt-bindings: tegra: Convert Tegra PMC bindings to YAML
> dt-bindings: soc: tegra-pmc: Add Tegra PMC clock bindings
> soc: tegra: Add Tegra PMC clocks registration into PMC driver
> dt-bindings: soc: tegra-pmc: Add id for Tegra PMC 32KHz blink clock
> soc: tegra: Add support for 32KHz blink clock
> clk: tegra: Remove tegra_pmc_clk_init along with clk ids
> dt-bindings: clock: tegra: Remove pmc clock ids from clock dt-bindings
> ASoC: tegra: Use device managed resource APIs to get the clock
> ASoC: tegra: Add audio mclk configuration
> ASoC: tegra: Add fallback implementation for audio mclk
> clk: tegra: Remove audio related clock enables from init_table
> ARM: dts: tegra: Add clock-cells property to pmc
> arm64: tegra: Add clock-cells property to Tegra PMC node
> ARM: tegra: Update sound node clocks in device tree
> arm64: tegra: smaug: Change clk_out_2 provider to pmc
> ASoC: nau8825: change Tegra clk_out_2 provider from tegra_car to pmc
>
> .../bindings/arm/tegra/nvidia,tegra20-pmc.txt | 300 -----------------
> .../bindings/arm/tegra/nvidia,tegra20-pmc.yaml | 354 +++++++++++++++++++++
> .../devicetree/bindings/sound/nau8825.txt | 2 +-
> arch/arm/boot/dts/tegra114-dalmore.dts | 8 +-
> arch/arm/boot/dts/tegra114.dtsi | 4 +-
> arch/arm/boot/dts/tegra124-apalis-v1.2.dtsi | 8 +-
> arch/arm/boot/dts/tegra124-apalis.dtsi | 8 +-
> arch/arm/boot/dts/tegra124-jetson-tk1.dts | 8 +-
> arch/arm/boot/dts/tegra124-nyan.dtsi | 8 +-
> arch/arm/boot/dts/tegra124-venice2.dts | 8 +-
> arch/arm/boot/dts/tegra124.dtsi | 4 +-
> arch/arm/boot/dts/tegra20.dtsi | 4 +-
> arch/arm/boot/dts/tegra30-apalis-v1.1.dtsi | 8 +-
> arch/arm/boot/dts/tegra30-apalis.dtsi | 8 +-
> arch/arm/boot/dts/tegra30-beaver.dts | 8 +-
> arch/arm/boot/dts/tegra30-cardhu.dtsi | 8 +-
> arch/arm/boot/dts/tegra30-colibri.dtsi | 8 +-
> arch/arm/boot/dts/tegra30.dtsi | 4 +-
> arch/arm64/boot/dts/nvidia/tegra132.dtsi | 4 +-
> arch/arm64/boot/dts/nvidia/tegra210-smaug.dts | 2 +-
> arch/arm64/boot/dts/nvidia/tegra210.dtsi | 6 +-
> drivers/clk/tegra/Makefile | 1 -
> drivers/clk/tegra/clk-id.h | 11 +-
> drivers/clk/tegra/clk-tegra-fixed.c | 32 +-
> drivers/clk/tegra/clk-tegra-pmc.c | 122 -------
> drivers/clk/tegra/clk-tegra114.c | 41 +--
> drivers/clk/tegra/clk-tegra124.c | 46 +--
> drivers/clk/tegra/clk-tegra20.c | 9 +-
> drivers/clk/tegra/clk-tegra210.c | 30 +-
> drivers/clk/tegra/clk-tegra30.c | 31 +-
> drivers/clk/tegra/clk.h | 1 -
> drivers/soc/tegra/pmc.c | 352 ++++++++++++++++++++
> include/dt-bindings/clock/tegra114-car.h | 18 +-
> include/dt-bindings/clock/tegra124-car-common.h | 18 +-
> include/dt-bindings/clock/tegra20-car.h | 2 +-
> include/dt-bindings/clock/tegra210-car.h | 18 +-
> include/dt-bindings/clock/tegra30-car.h | 18 +-
> include/dt-bindings/soc/tegra-pmc.h | 16 +
> sound/soc/tegra/tegra_alc5632.c | 28 +-
> sound/soc/tegra/tegra_asoc_utils.c | 125 ++++----
> sound/soc/tegra/tegra_asoc_utils.h | 3 +-
> sound/soc/tegra/tegra_max98090.c | 43 ++-
> sound/soc/tegra/tegra_rt5640.c | 43 ++-
> sound/soc/tegra/tegra_rt5677.c | 28 +-
> sound/soc/tegra/tegra_sgtl5000.c | 28 +-
> sound/soc/tegra/tegra_wm8753.c | 43 ++-
> sound/soc/tegra/tegra_wm8903.c | 43 ++-
> sound/soc/tegra/tegra_wm9712.c | 8 +-
> sound/soc/tegra/trimslice.c | 39 ++-
> 49 files changed, 1192 insertions(+), 777 deletions(-)
> delete mode 100644 Documentation/devicetree/bindings/arm/tegra/nvidia,tegra20-pmc.txt
> create mode 100644 Documentation/devicetree/bindings/arm/tegra/nvidia,tegra20-pmc.yaml
> delete mode 100644 drivers/clk/tegra/clk-tegra-pmc.c
> create mode 100644 include/dt-bindings/soc/tegra-pmc.h
>

I briefly looked through the patches and tested them in all possible
configurations. For now everything looks and works well.

You could add this to all patches:

Tested-by: Dmitry Osipenko <digetx@gmail.com>
Reviewed-by: Dmitry Osipenko <digetx@gmail.com>

\
 
 \ /
  Last update: 2020-01-08 00:02    [W:0.191 / U:2.412 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site