[lkml]   [2020]   [Jan]   [13]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
Messages in this thread
SubjectRe: [PATCH v8 02/18] soc: ti: k3: add navss ringacc driver

On 12/23/19 3:38 AM, Peter Ujfalusi wrote:
> Hi Santosh,
> On 23/12/2019 13.04, Peter Ujfalusi wrote:
>> From: Grygorii Strashko <>
>> The Ring Accelerator (RINGACC or RA) provides hardware acceleration to
>> enable straightforward passing of work between a producer and a consumer.
>> There is one RINGACC module per NAVSS on TI AM65x SoCs.
>> The RINGACC converts constant-address read and write accesses to equivalent
>> read or write accesses to a circular data structure in memory. The RINGACC
>> eliminates the need for each DMA controller which needs to access ring
>> elements from having to know the current state of the ring (base address,
>> current offset). The DMA controller performs a read or write access to a
>> specific address range (which maps to the source interface on the RINGACC)
>> and the RINGACC replaces the address for the transaction with a new address
>> which corresponds to the head or tail element of the ring (head for reads,
>> tail for writes). Since the RINGACC maintains the state, multiple DMA
>> controllers or channels are allowed to coherently share the same rings as
>> applicable. The RINGACC is able to place data which is destined towards
>> software into cached memory directly.
>> Supported ring modes:
>> - Ring Mode
>> - Messaging Mode
>> - Credentials Mode
>> - Queue Manager Mode
>> TI-SCI integration:
>> Texas Instrument's System Control Interface (TI-SCI) Message Protocol now
>> has control over Ringacc module resources management (RM) and Rings
>> configuration.
>> The corresponding support of TI-SCI Ringacc module RM protocol
>> introduced as option through DT parameters:
>> - ti,sci: phandle on TI-SCI firmware controller DT node
>> - ti,sci-dev-id: TI-SCI device identifier as per TI-SCI firmware spec
>> if both parameters present - Ringacc driver will configure/free/reset Rings
>> using TI-SCI Message Ringacc RM Protocol.
>> The Ringacc driver manages Rings allocation by itself now and requests
>> TI-SCI firmware to allocate and configure specific Rings only. It's done
>> this way because, Linux driver implements two stage Rings allocation and
>> configuration (allocate ring and configure ring) while TI-SCI Message
>> Protocol supports only one combined operation (allocate+configure).
>> Signed-off-by: Grygorii Strashko <>
>> Signed-off-by: Peter Ujfalusi <>
>> Reviewed-by: Tero Kristo <>
>> Tested-by: Keerthy <>
> Can you please giver your Acked-by for the ringacc patches if they are
> still OK from your point of view as you had offered to take them before
> I got comments from Lokesh.
Sure. But you really need to split the series so that dma engine and
soc driver patches can be applied independently. Can you please do that?

 \ /
  Last update: 2020-01-13 22:29    [W:0.063 / U:4.276 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site