lkml.org 
[lkml]   [2019]   [Sep]   [9]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH v4 2/2] net: phy: dp83867: Add SGMII mode type switching
Date
This patch adds ability to switch beetween two PHY SGMII modes.
Some hardware, for example, FPGA IP designs may use 6-wire mode
which enables differential SGMII clock to MAC.

Signed-off-by: Vitaly Gaiduk <vitaly.gaiduk@cloudbear.ru>
---
drivers/net/phy/dp83867.c | 19 +++++++++++++++++++
1 file changed, 19 insertions(+)

diff --git a/drivers/net/phy/dp83867.c b/drivers/net/phy/dp83867.c
index 1f1ecee..37fceaf 100644
--- a/drivers/net/phy/dp83867.c
+++ b/drivers/net/phy/dp83867.c
@@ -37,6 +37,7 @@
#define DP83867_STRAP_STS2 0x006f
#define DP83867_RGMIIDCTL 0x0086
#define DP83867_IO_MUX_CFG 0x0170
+#define DP83867_SGMIICTL 0x00D3
#define DP83867_10M_SGMII_CFG 0x016F
#define DP83867_10M_SGMII_RATE_ADAPT_MASK BIT(7)

@@ -61,6 +62,9 @@
#define DP83867_RGMII_TX_CLK_DELAY_EN BIT(1)
#define DP83867_RGMII_RX_CLK_DELAY_EN BIT(0)

+/* SGMIICTL bits */
+#define DP83867_SGMII_TYPE BIT(14)
+
/* STRAP_STS1 bits */
#define DP83867_STRAP_STS1_RESERVED BIT(11)

@@ -109,6 +113,7 @@ struct dp83867_private {
bool rxctrl_strap_quirk;
bool set_clk_output;
u32 clk_output_sel;
+ bool sgmii_ref_clk_en;
};

static int dp83867_ack_interrupt(struct phy_device *phydev)
@@ -197,6 +202,9 @@ static int dp83867_of_init(struct phy_device *phydev)
dp83867->rxctrl_strap_quirk = of_property_read_bool(of_node,
"ti,dp83867-rxctrl-strap-quirk");

+ dp83867->sgmii_ref_clk_en = of_property_read_bool(of_node,
+ "ti,sgmii-ref-clock-output-enable");
+
/* Existing behavior was to use default pin strapping delay in rgmii
* mode, but rgmii should have meant no delay. Warn existing users.
*/
@@ -389,6 +397,17 @@ static int dp83867_config_init(struct phy_device *phydev)

if (ret)
return ret;
+
+ val = phy_read_mmd(phydev, DP83867_DEVADDR, DP83867_SGMIICTL);
+ /* SGMII type is set to 4-wire mode by default.
+ * If we place appropriate property in dts (see above)
+ * switch on 6-wire mode.
+ */
+ if (dp83867->sgmii_ref_clk_en)
+ val |= DP83867_SGMII_TYPE;
+ else
+ val &= ~DP83867_SGMII_TYPE;
+ phy_write_mmd(phydev, DP83867_DEVADDR, DP83867_SGMIICTL, val);
}

/* Enable Interrupt output INT_OE in CFG3 register */
--
2.7.4
\
 
 \ /
  Last update: 2019-09-09 19:19    [W:0.082 / U:1.348 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site