[lkml]   [2019]   [Sep]   [3]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
Messages in this thread
Subject[PATCH v2 0/5] i3c: remove device if failed on pre_assign_dyn_addr()
This patch series remove the devices that fail during
pre_assign_dyn_addr() and were being sent on DEFSVLS command.
With the change above, during the i3c_master_add_i3c_dev_locked() is
necessary to check if the device has i3c_boardinfo and try to assign the
i3c_dev_boardinfo->init_dyn_addr if there no oldev. This change will
allow to describe in DT device with preferable dynamic address but without
static address.

Change in v2:
- Move out detach/free the i3c_dev_desc from pre_assign_dyn_addr()
- Change i3c_master_search_i3c_boardinfo(newdev) to
- Add fixes, stable tags on patch 2
- Add a note for no guarantee of 'assigned-address' use

Vitor Soares (5):
i3c: master: detach and free device if pre_assign_dyn_addr() fails
i3c: master: make sure ->boardinfo is initialized in
dt-bindings: i3c: make 'assigned-address' valid if static address == 0
dt-bindings: i3c: add a note for no guarantee of 'assigned-address' use
i3c: master: dw: reattach device on first available location of
address table

Documentation/devicetree/bindings/i3c/i3c.txt | 15 ++++++--
drivers/i3c/master.c | 49 ++++++++++++++++++++++-----
drivers/i3c/master/dw-i3c-master.c | 16 +++++++++
3 files changed, 68 insertions(+), 12 deletions(-)


 \ /
  Last update: 2019-09-03 12:37    [W:0.062 / U:4.740 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site