lkml.org 
[lkml]   [2019]   [Sep]   [25]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: [Patch v3 6/8] media: i2c: ov2659: Add powerdown/reset gpio handling
Hi Benoit,

On Tue, Sep 24, 2019 at 11:44:12AM -0500, Benoit Parrot wrote:
> On some board it is possible that the sensor 'powerdown' and or 'reset'
> pin might be controlled by gpio instead of being tied.
>
> To implement we add pm_runtime support which will handle the power
> up/down sequence when it is available otherwise the sensor will be
> powered on at module insertion/probe and powered off at module removal.
>
> Now originally the driver assumed that the sensor would always stay
> powered and keep its register setting. We cannot assume this anymore, so
> every time we "power up" we need to re-program the initial registers
> configuration first. This was previously done only at probe time.
>
> Signed-off-by: Benoit Parrot <bparrot@ti.com>

Thanks for the update.

I missed the control interface is accessible also when the device is not
streaming, and the driver doesn't appear to power on the sensor for that,
leading to a failing I²C write.

Could you address that as well, either here or as a separate patch? E.g.
the smiapp driver does this.

--
Kind regards,

Sakari Ailus
sakari.ailus@linux.intel.com

\
 
 \ /
  Last update: 2019-09-25 11:52    [W:0.099 / U:0.844 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site