lkml.org 
[lkml]   [2019]   [Sep]   [17]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH 4/5] dt-bindings: mfd: da9062: add regulator gpio enable/disable documentation
Date
At the gpio-based regulator enable/disable documentation. This property
can be applied to each subnode within the 'regulators' node so each
regulator can be configured differently.

Signed-off-by: Marco Felsch <m.felsch@pengutronix.de>
---
Documentation/devicetree/bindings/mfd/da9062.txt | 7 +++++++
1 file changed, 7 insertions(+)

diff --git a/Documentation/devicetree/bindings/mfd/da9062.txt b/Documentation/devicetree/bindings/mfd/da9062.txt
index 9d9820d8177d..3d4b90bf8ea6 100644
--- a/Documentation/devicetree/bindings/mfd/da9062.txt
+++ b/Documentation/devicetree/bindings/mfd/da9062.txt
@@ -75,6 +75,13 @@ Sub-nodes:
same. Also the gpio phandle must refer to to the dlg,da9062-gpio device
other gpios are not allowed and make no sense.

+ - dlg,ena-sense-gpios : The GPIO reference which should be used by the
+ regulator to enable/disable the output. If the signal is active the
+ regulator is on else it is off. Attention: Sharing the same gpio for other
+ purposes or across multiple regulators is possible but the gpio settings
+ must be the same. Also the gpio phandle must refer to to the
+ dlg,da9062-gpio device other gpios are not allowed and make no sense.
+
- rtc : This node defines settings required for the Real-Time Clock associated
with the DA9062. There are currently no entries in this binding, however
compatible = "dlg,da9062-rtc" should be added if a node is created.
--
2.20.1
\
 
 \ /
  Last update: 2019-09-17 14:44    [W:0.091 / U:2.452 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site