[lkml]   [2019]   [Sep]   [11]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
Messages in this thread
SubjectRe: [PATCH RFC 02/14] drivers: irqchip: pdc: Do not toggle IRQ_ENABLE during mask/unmask
On Thu, Sep 05 2019 at 18:39 -0600, Stephen Boyd wrote:
>Quoting Lina Iyer (2019-08-29 11:11:51)
>> When an interrupt is to be serviced, the convention is to mask the
>> interrupt at the chip and unmask after servicing the interrupt. Enabling
>> and disabling the interrupt at the PDC irqchip causes an interrupt storm
>> due to the way dual edge interrupts are handled in hardware.
>> Skip configuring the PDC when the IRQ is masked and unmasked, instead
>> use the irq_enable/irq_disable callbacks to toggle the IRQ_ENABLE
>> register at the PDC. The PDC's IRQ_ENABLE register is only used during
>> the monitoring mode when the system is asleep and is not needed for
>> active mode detection.
>I think this is saying that we want to always let the line be sent
>through the PDC to the parent irqchip, in this case GIC, so that we
>don't get an interrupt storm for dual edge interrupts? Why does dual
>edge interrupts cause a problem?
I am not sure about the hardware details, but the PDC designers did not
expect enable and disable to be called whenever the interrupt is
handled. This specially becomes a problem for dual edge interrupts which
seems to generate a interrupt storm when enabled/disabled while handling
the interrupt.


 \ /
  Last update: 2019-09-11 18:18    [W:0.132 / U:1.228 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site