[lkml]   [2019]   [Aug]   [30]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
Messages in this thread
Subject[PATCH v3 0/7] add support USB for MT8183
This series support USB DRD controller and enable it's remote
wakeup functoin for MT8183, they depend on the following
series patches:

1. this series add support MT6358 PMIC
[v5,01/10] mfd: mt6397: clean up code

2. this series add support pericfg syscon
[v2,1/2] dt-bindings: clock: mediatek: add pericfg for MT8183

3. add property mediatek,discth for tphy
[06/11] phy: phy-mtk-tphy: add a property for disconnect threshold

v3 changes:
1. changes micros define
2. remove #reset-cell
3. update dependent series

v2 changes:
add patch [7/7]

Chunfeng Yun (7):
dt-bindings: usb: mtu3: support USB wakeup for MT8183
dt-bindings: usb: mtk-xhci: support USB wakeup for MT8183
usb: mtu3: support ip-sleep wakeup for MT8183
usb: mtk-xhci: support ip-sleep wakeup for MT8183
arm64: dts: mt8183: add usb and phy nodes
arm64: dts: mt8183: enable USB remote wakeup
arm64: dts: mt8183: tune disconnect threshold of u2phy

.../bindings/usb/mediatek,mtk-xhci.txt | 1 +
.../devicetree/bindings/usb/mediatek,mtu3.txt | 1 +
arch/arm64/boot/dts/mediatek/mt8183-evb.dts | 23 +++++++
arch/arm64/boot/dts/mediatek/mt8183.dtsi | 63 +++++++++++++++++++
drivers/usb/host/xhci-mtk.c | 14 ++++-
drivers/usb/mtu3/mtu3_host.c | 14 ++++-
6 files changed, 114 insertions(+), 2 deletions(-)


 \ /
  Last update: 2019-08-30 09:42    [W:0.594 / U:4.060 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site