lkml.org 
[lkml]   [2019]   [Aug]   [27]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH v2 07/15] dt: thermal: tsens: Document interrupt support in tsens driver
Date
Define two new required properties to define interrupts and
interrupt-names for tsens.

Signed-off-by: Amit Kucheria <amit.kucheria@linaro.org>
---
Documentation/devicetree/bindings/thermal/qcom-tsens.txt | 8 ++++++++
1 file changed, 8 insertions(+)

diff --git a/Documentation/devicetree/bindings/thermal/qcom-tsens.txt b/Documentation/devicetree/bindings/thermal/qcom-tsens.txt
index 673cc1831ee9d..686bede72f846 100644
--- a/Documentation/devicetree/bindings/thermal/qcom-tsens.txt
+++ b/Documentation/devicetree/bindings/thermal/qcom-tsens.txt
@@ -22,6 +22,8 @@ Required properties:

- #thermal-sensor-cells : Should be 1. See ./thermal.txt for a description.
- #qcom,sensors: Number of sensors in tsens block
+- interrupts: Interrupts generated from Always-On subsystem (AOSS)
+- interrupt-names: Must be one of the following: "uplow", "critical"
- Refer to Documentation/devicetree/bindings/nvmem/nvmem.txt to know how to specify
nvmem cells

@@ -40,6 +42,9 @@ tsens0: thermal-sensor@c263000 {
reg = <0xc263000 0x1ff>, /* TM */
<0xc222000 0x1ff>; /* SROT */
#qcom,sensors = <13>;
+ interrupts = <GIC_SPI 506 IRQ_TYPE_LEVEL_HIGH>;
+ interrupt-names = "uplow";
+
#thermal-sensor-cells = <1>;
};

@@ -51,5 +56,8 @@ tsens: thermal-sensor@4a9000 {
nvmem-cells = <&tsens_caldata>;
nvmem-cell-names = "calib";
#qcom,sensors = <10>;
+ interrupts = <GIC_SPI 506 IRQ_TYPE_LEVEL_HIGH>;
+ interrupt-names = "uplow";
+
#thermal-sensor-cells = <1>;
};
--
2.17.1
\
 
 \ /
  Last update: 2019-08-27 14:16    [W:0.264 / U:3.620 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site