lkml.org 
[lkml]   [2019]   [Aug]   [20]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH] bonding: force enable lacp port after link state recovery for 802.3ad
Date
From: Sha Zhang <zhangsha.zhang@huawei.com>

After the commit 334031219a84 ("bonding/802.3ad: fix slave link
initialization transition states") merged,
the slave's link status will be changed to BOND_LINK_FAIL
from BOND_LINK_DOWN in the following scenario:
- Driver reports loss of carrier and
bonding driver receives NETDEV_CHANGE notifier
- slave's duplex and speed is zerod and
its port->is_enabled is cleard to 'false';
- Driver reports link recovery and
bonding driver receives NETDEV_UP notifier;
- If speed/duplex getting failed here, the link status
will be changed to BOND_LINK_FAIL;
- The MII monotor later recover the slave's speed/duplex
and set link status to BOND_LINK_UP, but remains
the 'port->is_enabled' to 'false'.

In this scenario, the lacp port will not be enabled even its speed
and duplex are valid. The bond will not send LACPDU's, and its
state is 'AD_STATE_DEFAULTED' forever. The simplest fix I think
is to force enable lacp after port slave speed check in
bond_miimon_commit. As enabled, the lacp port can run its state machine
normally after link recovery.

Signed-off-by: Sha Zhang <zhangsha.zhang@huawei.com>
---
drivers/net/bonding/bond_main.c | 8 +++++++-
1 file changed, 7 insertions(+), 1 deletion(-)

diff --git a/drivers/net/bonding/bond_main.c b/drivers/net/bonding/bond_main.c
index 931d9d9..379253a 100644
--- a/drivers/net/bonding/bond_main.c
+++ b/drivers/net/bonding/bond_main.c
@@ -2194,6 +2194,7 @@ static void bond_miimon_commit(struct bonding *bond)
{
struct list_head *iter;
struct slave *slave, *primary;
+ struct port *port;

bond_for_each_slave(bond, slave, iter) {
switch (slave->new_link) {
@@ -2205,8 +2206,13 @@ static void bond_miimon_commit(struct bonding *bond)
* link status
*/
if (BOND_MODE(bond) == BOND_MODE_8023AD &&
- slave->link == BOND_LINK_UP)
+ slave->link == BOND_LINK_UP) {
bond_3ad_adapter_speed_duplex_changed(slave);
+ if (slave->duplex == DUPLEX_FULL) {
+ port = &(SLAVE_AD_INFO(slave)->port);
+ port->is_enabled = true;
+ }
+ }
continue;

case BOND_LINK_UP:
--
1.8.3.1
\
 
 \ /
  Last update: 2019-08-20 15:38    [W:0.077 / U:6.040 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site