lkml.org 
[lkml]   [2019]   [Aug]   [2]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
SubjectRe: [PATCH v7 07/20] clk: tegra: clk-periph: Add save and restore support
From
Date
31.07.2019 3:20, Sowjanya Komatineni пишет:
> This patch implements save and restore context for peripheral fixed
> clock ops, peripheral gate clock ops, sdmmc mux clock ops, and
> peripheral clock ops.
>
> During system suspend, core power goes off and looses the settings
> of the Tegra CAR controller registers.
>
> So during suspend entry clock and reset state of peripherals is saved
> and on resume they are restored to have clocks back to same rate and
> state as before suspend.
>
> Acked-by: Thierry Reding <treding@nvidia.com>
> Signed-off-by: Sowjanya Komatineni <skomatineni@nvidia.com>
> ---
> drivers/clk/tegra/clk-periph-fixed.c | 33 ++++++++++++++++++++++++++++++++
> drivers/clk/tegra/clk-periph-gate.c | 34 +++++++++++++++++++++++++++++++++
> drivers/clk/tegra/clk-periph.c | 37 ++++++++++++++++++++++++++++++++++++
> drivers/clk/tegra/clk-sdmmc-mux.c | 28 +++++++++++++++++++++++++++
> drivers/clk/tegra/clk.h | 6 ++++++
> 5 files changed, 138 insertions(+)
>
> diff --git a/drivers/clk/tegra/clk-periph-fixed.c b/drivers/clk/tegra/clk-periph-fixed.c
> index c088e7a280df..21b24530fa00 100644
> --- a/drivers/clk/tegra/clk-periph-fixed.c
> +++ b/drivers/clk/tegra/clk-periph-fixed.c
> @@ -60,11 +60,44 @@ tegra_clk_periph_fixed_recalc_rate(struct clk_hw *hw,
> return (unsigned long)rate;
> }
>
> +static int tegra_clk_periph_fixed_save_context(struct clk_hw *hw)
> +{
> + struct tegra_clk_periph_fixed *fixed = to_tegra_clk_periph_fixed(hw);
> + u32 mask = 1 << (fixed->num % 32);

This could be BIT(fixed->num % 32).

> + fixed->enb_ctx = readl_relaxed(fixed->base + fixed->regs->enb_reg) &
> + mask;
> + fixed->rst_ctx = readl_relaxed(fixed->base + fixed->regs->rst_reg) &
> + mask;

The enb_ctx/rst_ctx are booleans, while you assigning an integer value
here. You're getting away here because bool is an 32bit unsigned int,
but you shouldn't rely on it and always explicitly convert to a bool.

> + return 0;
> +}
> +
> +static void tegra_clk_periph_fixed_restore_context(struct clk_hw *hw)
> +{
> + struct tegra_clk_periph_fixed *fixed = to_tegra_clk_periph_fixed(hw);
> + u32 mask = 1 << (fixed->num % 32);
> +
> + if (fixed->enb_ctx)
> + writel_relaxed(mask, fixed->base + fixed->regs->enb_set_reg);
> + else
> + writel_relaxed(mask, fixed->base + fixed->regs->enb_clr_reg);
> +
> + udelay(2);

Will be better to read out and compare the hardware's state with the
restored one, then bail out if the state is unchanged.

Shouldn't it be fence_udelay()?

> + if (!fixed->rst_ctx) {
> + udelay(5); /* reset propogation delay */

Why delaying is done before the writing to the reset register?

> + writel_relaxed(mask, fixed->base + fixed->regs->rst_reg);

I'm not quite sure what's going on here, this looks wrong.

1. rst_reg points to RST_DEVICES_x
2. Each bit of RST_DEVICES_x represents the reset-assertion state of
each individual device
3. By writing to rst_reg, all (!) devices are deasserted, except the one
device which corresponds to the mask
4. The reset is asserted for a single device, while !fixed->rst_ctx
means that it actually should be deasserted (?)

Apparently you should use rst_set_reg / rst_clr_reg.

> + }

What about the case where rst_ctx=true?

> +}

> @@ -517,6 +517,8 @@ struct tegra_clk_periph_gate {
> int clk_num;
> int *enable_refcnt;
> const struct tegra_clk_periph_regs *regs;
> + bool clk_state_ctx;
> + bool rst_state_ctx;
> };
>
> #define to_clk_periph_gate(_hw) \
> @@ -543,6 +545,8 @@ struct tegra_clk_periph_fixed {
> unsigned int mul;
> unsigned int div;
> unsigned int num;
> + bool enb_ctx;
> + bool rst_ctx;
> };

I'd expect these to be bool:1.

\
 
 \ /
  Last update: 2019-08-02 14:33    [W:0.252 / U:3.160 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site