lkml.org 
[lkml]   [2019]   [Aug]   [2]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH] ARM: dts: stm32: move ltdc pinctrl on stm32mp157a dk1 board
Date
The ltdc pinctrl must be in the display controller node and
not in the peripheral node (hdmi bridge).

Signed-off-by: Yannick Fertré <yannick.fertre@st.com>
---
arch/arm/boot/dts/stm32mp157a-dk1.dts | 6 +++---
1 file changed, 3 insertions(+), 3 deletions(-)

diff --git a/arch/arm/boot/dts/stm32mp157a-dk1.dts b/arch/arm/boot/dts/stm32mp157a-dk1.dts
index f3f0e37..1285cfc 100644
--- a/arch/arm/boot/dts/stm32mp157a-dk1.dts
+++ b/arch/arm/boot/dts/stm32mp157a-dk1.dts
@@ -99,9 +99,6 @@
reset-gpios = <&gpioa 10 GPIO_ACTIVE_LOW>;
interrupts = <1 IRQ_TYPE_EDGE_FALLING>;
interrupt-parent = <&gpiog>;
- pinctrl-names = "default", "sleep";
- pinctrl-0 = <&ltdc_pins_a>;
- pinctrl-1 = <&ltdc_pins_sleep_a>;
status = "okay";

ports {
@@ -276,6 +273,9 @@
};

&ltdc {
+ pinctrl-names = "default", "sleep";
+ pinctrl-0 = <&ltdc_pins_a>;
+ pinctrl-1 = <&ltdc_pins_sleep_a>;
status = "okay";

port {
--
2.7.4
\
 
 \ /
  Last update: 2019-08-02 16:09    [W:0.057 / U:4.640 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site