[lkml]   [2019]   [Jul]   [3]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
Messages in this thread
SubjectRe: [PATCH v3] pinctrl: qcom: Add irq_enable callback for msm gpio
On Tue, Jun 25, 2019 at 4:14 PM Neeraj Upadhyay <> wrote:

> From: Srinivas Ramana <>
> Introduce the irq_enable callback which will be same as irq_unmask
> except that it will also clear the status bit before unmask.
> This will help in clearing any erroneous interrupts that would
> have got latched when the interrupt is not in use.
> There may be devices like UART which can use the same gpio line
> for data rx as well as a wakeup gpio when in suspend. The data that
> was flowing on the line may latch the interrupt and when we enable
> the interrupt before going to suspend, this would trigger the
> unexpected interrupt. This change helps clearing the interrupt
> so that these unexpected interrupts gets cleared.
> Signed-off-by: Srinivas Ramana <>
> Signed-off-by: Neeraj Upadhyay <>
> ---
> Changes since v2:
> - Renamed function to msm_gpio_irq_clear_unmask()

Patch applied, unless Bjorn complains!

Linus Walleij

 \ /
  Last update: 2019-07-03 10:27    [W:0.033 / U:1.372 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site