lkml.org 
[lkml]   [2019]   [Jul]   [1]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH v2 07/11] dt-bindings: mmc: arasan: Add optional properties for Arasan SDHCI
Date
Add optional propeties for Arasan SDHCI which are used to set clk delays
for different speed modes in the controller.

Signed-off-by: Manish Narani <manish.narani@xilinx.com>
---
Documentation/devicetree/bindings/mmc/arasan,sdhci.txt | 15 +++++++++++++++
1 file changed, 15 insertions(+)

diff --git a/Documentation/devicetree/bindings/mmc/arasan,sdhci.txt b/Documentation/devicetree/bindings/mmc/arasan,sdhci.txt
index 7c79496..7425d52 100644
--- a/Documentation/devicetree/bindings/mmc/arasan,sdhci.txt
+++ b/Documentation/devicetree/bindings/mmc/arasan,sdhci.txt
@@ -49,6 +49,21 @@ Optional Properties:
properly. Test mode can be used to force the controller to function.
- xlnx,int-clock-stable-broken: when present, the controller always reports
that the internal clock is stable even when it is not.
+ - clk-phase-legacy: Input/Output Clock Delay pair in degrees for Legacy Mode.
+ - clk-phase-mmc-hs: Input/Output Clock Delay pair degrees for MMC HS.
+ - clk-phase-sd-hs: Input/Output Clock Delay pair in degrees for SD HS.
+ - clk-phase-uhs-sdr12: Input/Output Clock Delay pair in degrees for SDR12.
+ - clk-phase-uhs-sdr25: Input/Output Clock Delay pair in degrees for SDR25.
+ - clk-phase-uhs-sdr50: Input/Output Clock Delay pair in degrees for SDR50.
+ - clk-phase-uhs-sdr104: Input/Output Clock Delay pair in degrees for SDR104.
+ - clk-phase-uhs-ddr50: Input/Output Clock Delay pair in degrees for SD DDR50.
+ - clk-phase-mmc-ddr52: Input/Output Clock Delay pair in degrees for MMC DDR52.
+ - clk-phase-mmc-hs200: Input/Output Clock Delay pair in degrees for MMC HS200.
+ - clk-phase-mmc-hs400: Input/Output Clock Delay pair in degrees for MMC HS400.
+
+ Above mentioned are the clock (phase) delays which are to be configured in the
+ controller while switching to particular speed mode. If not specified, driver
+ will configure the default value defined for particular mode in it.

Example:
sdhci@e0100000 {
--
2.1.1
\
 
 \ /
  Last update: 2019-07-01 07:31    [W:0.272 / U:1.000 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site