[lkml]   [2019]   [Jun]   [28]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
Messages in this thread
SubjectRE: [PATCH v5 05/26] leds: core: Add support for composing LED class device names
From: Linus Walleij
> Sent: 28 June 2019 09:46
> A problem with LEDs is that it invites bikeshedding because it is too
> relateable.

Bikeshedding leds :-)

It also isn't at all clear how to handle bi-colour and tri-colour leds.
ISTR the usual interface lets you set the brightness, but more often
leds are single brightness but multi-colour.
Eg the ethernet 'speed' led which is (usually) off/orange/green.

Changing the brightness either means changing the current or using PWM.
Both really require more hardware support than changing colours.

I've done some led driving (for a front panel) from a PLD (small FPGA).
As well as the obvious things I did:
- dim: 1/8th on at 80Hz.
- flash: 1/8th on at 4Hz.
- orange: 50-50 red-green at 80Hz on an RGB led.

There was also the 'ethernet activity' led which could either be driven
by the hardware, or forced on/off/flash by the driver.
If driven by the hardware, the software could read the current state.

None of this really fitted the Linux leds interface.


Registered Address Lakeside, Bramley Road, Mount Farm, Milton Keynes, MK1 1PT, UK
Registration No: 1397386 (Wales)
 \ /
  Last update: 2019-06-28 15:31    [W:0.191 / U:2.736 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site