[lkml]   [2019]   [Jun]   [19]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
Messages in this thread
SubjectRe: [PATCH v3 0/4] Ethernet PHY reset GPIO updates for Amlogic SoCs
Martin Blumenstingl <> writes:

> While trying to add the Ethernet PHY interrupt on the X96 Max I found
> that the current reset line definition is incorrect. Patch #1 fixes
> this.
> Since the fix requires moving from the deprecated "snps,reset-gpio"
> property to the generic Ethernet PHY reset bindings I decided to move
> all Amlogic boards over to the non-deprecated bindings. That's what
> patches #2 and #3 do.
> Finally I found that Odroid-N2 doesn't define the Ethernet PHY's reset
> GPIO yet. I don't have that board so I can't test whether it really
> works but based on the schematics it should.
> This series is a partial successor to "stmmac: honor the GPIO flags
> for the PHY reset GPIO" from [0]. I decided not to take Linus W.'s
> Reviewed-by from patch #4 of that series because I had to change the
> wording and I want to be sure that he's happy with that now.
> One quick note regarding patches #1 and #4: I decided to violate the
> "max 80 characters per line" (by 4 characters) limit because I find
> that the result is easier to read then it would be if I split the
> line.
> Changes since v1 at [1]:
> - fixed the reset deassert delay for RTL8211F PHYs - spotted by Robin
> Murphy (thank you). according to the public RTL8211E datasheet the
> correct values seem to be: 10ms assert, 30ms deassert
> - fixed the reset assert and deassert delays for IP101GR PHYs. There
> are two values given in the public datasheet, use the higher one
> (10ms instead of 2.5)
> - update the patch descriptions to quote the datasheets (the RTL8211F
> quotes are taken from the public RTL8211E datasheet because as far
> as I can tell the reset sequence is identical on both PHYs)
> Changes since v2 at [2]:
> - add Neil's Reviewed/Acked/Tested-by's (thank you!)
> - rebased on top of "arm64: dts: meson-g12a-x96-max: add sound card"
> [0]
> [1]
> [2]

Queued for v5.3...

> Martin Blumenstingl (4):
> arm64: dts: meson: g12a: x96-max: fix the Ethernet PHY reset line
> ARM: dts: meson: switch to the generic Ethernet PHY reset bindings branch v5.3/dt

> arm64: dts: meson: use the generic Ethernet PHY reset GPIO bindings
> arm64: dts: meson: g12b: odroid-n2: add the Ethernet PHY reset line

The other 3 in v5.3/dt64,



 \ /
  Last update: 2019-06-20 05:35    [W:0.049 / U:5.680 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site