lkml.org 
[lkml]   [2019]   [May]   [8]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
From
SubjectRE: [EXT] Re: [PATCH v5 4/5] usb: host: Stops USB controller init if PLL fails to lock
Date


> -----Original Message-----
> From: Alan Stern [mailto:stern@rowland.harvard.edu]
> Sent: 2019年5月9日 0:50
> To: Yinbo Zhu <yinbo.zhu@nxp.com>
> Cc: Xiaobo Xie <xiaobo.xie@nxp.com>; Greg Kroah-Hartman
> <gregkh@linuxfoundation.org>; Ramneek Mehresh
> <ramneek.mehresh@freescale.com>; Nikhil Badola
> <nikhil.badola@freescale.com>; Ran Wang <ran.wang_1@nxp.com>;
> linux-usb@vger.kernel.org; linux-kernel@vger.kernel.org; Jiafei Pan
> <jiafei.pan@nxp.com>; Suresh Gupta <suresh.gupta@freescale.com>
> Subject: [EXT] Re: [PATCH v5 4/5] usb: host: Stops USB controller init if PLL fails to
> lock
>
> Caution: EXT Email
>
> On Wed, 8 May 2019, Yinbo Zhu wrote:
>
> > From: Ramneek Mehresh <ramneek.mehresh@freescale.com>
> >
> > USB erratum-A006918 workaround tries to start internal PHY inside
> > uboot (when PLL fails to lock). However, if the workaround also fails,
> > then USB initialization is also stopped inside Linux.
> > Erratum-A006918 workaround failure creates "fsl,erratum_a006918"
> > node in device-tree. Presence of this node in device-tree is used to
> > stop USB controller initialization in Linux
> >
> > Signed-off-by: Ramneek Mehresh <ramneek.mehresh@freescale.com>
> > Signed-off-by: Suresh Gupta <suresh.gupta@freescale.com>
> > Signed-off-by: Yinbo Zhu <yinbo.zhu@nxp.com>
> > ---
> > Change in v5:
> > use dev_warn() instead of pr_warn()
> >
> > drivers/usb/host/ehci-fsl.c | 5 +++++
> > drivers/usb/host/fsl-mph-dr-of.c | 3 ++-
> > 2 files changed, 7 insertions(+), 1 deletions(-)
> >
> > diff --git a/drivers/usb/host/ehci-fsl.c b/drivers/usb/host/ehci-fsl.c
> > index 1634ac8..90550a6 100644
> > --- a/drivers/usb/host/ehci-fsl.c
> > +++ b/drivers/usb/host/ehci-fsl.c
> > @@ -236,6 +236,11 @@ static int ehci_fsl_setup_phy(struct usb_hcd *hcd,
> > portsc |= PORT_PTS_PTW;
> > /* fall through */
> > case FSL_USB2_PHY_UTMI:
> > + if (pdata->has_fsl_erratum_a006918) {
> > + dev_warn(dev, "USB PHY clock invalid\n");
> > + return -EINVAL;
> > + }
> > +
>
> You need to add a "Fall through" comment between these two cases.
> > case FSL_USB2_PHY_UTMI_DUAL:
> > /* PHY_CLK_VALID bit is de-featured from all controller
> > * versions below 2.4 and is to be checked only for
>
> Alan Stern
Hi Alan Stern,

Your meaning is to remove "/* fall through*/" or add the erratum commont replace "/* fall through*/"

Regards,
Yinbo
\
 
 \ /
  Last update: 2019-05-09 05:59    [W:0.080 / U:5.880 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site