[lkml]   [2019]   [May]   [27]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
Messages in this thread
Patch in this message
Subject[PATCH v6 4/6] dt-bindings: display: hdmi-connector: Support DDC bus enable
From: Ondrej Jirman <>

Some Allwinner SoC using boards (Orange Pi 3 for example) need to enable
on-board voltage shifting logic for the DDC bus using a gpio to be able
to access DDC bus. Use ddc-en-gpios property on the hdmi-connector to
model this.

Add binding documentation for optional ddc-en-gpios property.

Signed-off-by: Ondrej Jirman <>
.../devicetree/bindings/display/connector/hdmi-connector.txt | 1 +
1 file changed, 1 insertion(+)

diff --git a/Documentation/devicetree/bindings/display/connector/hdmi-connector.txt b/Documentation/devicetree/bindings/display/connector/hdmi-connector.txt
index 508aee461e0d..aeb07c4bd703 100644
--- a/Documentation/devicetree/bindings/display/connector/hdmi-connector.txt
+++ b/Documentation/devicetree/bindings/display/connector/hdmi-connector.txt
@@ -9,6 +9,7 @@ Optional properties:
- label: a symbolic name for the connector
- hpd-gpios: HPD GPIO number
- ddc-i2c-bus: phandle link to the I2C controller used for DDC EDID probing
+- ddc-en-gpios: signal to enable DDC bus

Required nodes:
- Video port for HDMI input
 \ /
  Last update: 2019-05-27 18:23    [W:0.075 / U:0.928 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site