lkml.org 
[lkml]   [2019]   [May]   [21]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH v3 2/2] mtd: nand: raw: brcmnand: fallback to detected ecc-strength, ecc-step-size
Date
This change supports nand-ecc-step-size and nand-ecc-strength fields in
brcmnand DT node to be optional.
see: Documentation/devicetree/bindings/mtd/brcm,brcmnand.txt

If both nand-ecc-strength and nand-ecc-step-size are not specified in
device tree node for NAND, raw NAND layer does detect ECC information by
reading ONFI extended parameter page for parts using ONFI >= 2.1.
In case of non-ONFI NAND parts there could be a nand_id table entry with
ECC information. If there is valid device tree entry for nand-ecc-strength
and nand-ecc-step-size fields it still shall override the detected values.

Signed-off-by: Kamal Dasu <kdasu.kdev@gmail.com>
---
drivers/mtd/nand/raw/brcmnand/brcmnand.c | 11 +++++++++++
1 file changed, 11 insertions(+)

diff --git a/drivers/mtd/nand/raw/brcmnand/brcmnand.c b/drivers/mtd/nand/raw/brcmnand/brcmnand.c
index ce0b8ff..1bdd490 100644
--- a/drivers/mtd/nand/raw/brcmnand/brcmnand.c
+++ b/drivers/mtd/nand/raw/brcmnand/brcmnand.c
@@ -2144,6 +2144,17 @@ static int brcmnand_setup_dev(struct brcmnand_host *host)
return -EINVAL;
}

+ if (chip->ecc.mode != NAND_ECC_NONE &&
+ (!chip->ecc.size || !chip->ecc.strength)) {
+ if (chip->base.eccreq.step_size && chip->base.eccreq.strength) {
+ /* use detected ECC parameters */
+ chip->ecc.size = chip->base.eccreq.step_size;
+ chip->ecc.strength = chip->base.eccreq.strength;
+ dev_info(ctrl->dev, "Using ECC step-size %d, strength %d\n",
+ chip->ecc.size, chip->ecc.strength);
+ }
+ }
+
switch (chip->ecc.size) {
case 512:
if (chip->ecc.algo == NAND_ECC_HAMMING)
--
1.9.0.138.g2de3478
\
 
 \ /
  Last update: 2019-05-21 16:45    [W:0.043 / U:33.484 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site