[lkml]   [2019]   [May]   [16]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
Messages in this thread
SubjectRe: [PATCH 4/4] arm64: DTS: allwinner: a64: enable ANX6345 bridge on Teres-I
On Wed, May 15, 2019 at 08:08:57AM -0700, Vasily Khoruzhick wrote:
> On Wed, May 15, 2019 at 12:32 AM Torsten Duwe <> wrote:
> >
> > It does comply with the bindings. The ports are all optional.
> > As far as DT is concerned, the signal path ends here. This is also the
> > final component _required_ to get the Linux kernel DRI up and running.
> Ugh, then bindings should be fixed. It's not optional. It may work if
> bootloader enables power for you, but it won't if you disable display
> driver in u-boot.

I double-checked. On the Teres-I, mentioning the panel _is_ optional.
PD23 powers down panel and backlight as much as possible, see
24bd5d2cb93bc arm64: dts: allwinner: a64: teres-i: enable backlight
(currently only in Maxime's repo) and the Teres-I schematics...

And the driver in your repo neatly guards all accesses with
"if (anx6345->panel)" -- good!
But I found the Vdds are required, so I added them as such.

> I guess you're testing it with older version of anx6345. Newer version
> that supports power management [1] needs startup delay for panel.
> Another issue that you're seeing is that backlight is not disabled on
> DPMS events. All in all, you need to describe panel in dts.
> [1]

> > Should I also have added a Tested-by: ? ;-)
> I don't have Teres, so I haven't tested these.

*I* have one, and this works. I'll retest with your newer driver,
just in case. Nonetheless, the changes in this series should be fine.
Sending out v2 in a moment...


 \ /
  Last update: 2019-05-16 17:49    [W:0.095 / U:0.128 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site