[lkml]   [2019]   [May]   [13]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
Messages in this thread
Subject[PATCH 0/3] mmc: meson-gx: add ddr-access-quirk support
On the Amlogic G12A SoC family, (only) the SDIO controller fails to access
the data from DDR, leading to a broken controller.

Add the amlogic,ddr-access-quirk property so signal this particular
controller has this bug and needs a quirk to work properly.

But each MMC controller has 1,5KiB of SRAM after the registers, that can
be used as bounce buffer to avoid direct DDR access from the integrated
DMAs (this SRAM may be used by the boot ROM when DDR is not yet initialized).

The quirk is to disable the chained descriptor for this controller, and
use this SRAM memory zone as buffer for the bounce buffer fallback mode.

The performance hit hasn't been evaluated, but the fix has been tested
using a WiFi AP6398S SDIO module, and the iperf3 Bandwidth measurement gave
55.2 Mbits/sec over a 63 Hours long test, with the SDIO ios set as High-Speed
at 50MHz clock. It gave around 170 Mbits/sec as SDR104 and 200MHz clock.

Neil Armstrong (3):
dt-bindings: mmc: meson-gx: add ddr-access-quirk property
mmc: meson-gx: add ddr-access-quirk
arm64: dts: meson-g12a: add ddr-access-quirk property to SDIO

.../bindings/mmc/amlogic,meson-gx.txt | 4 ++
arch/arm64/boot/dts/amlogic/meson-g12a.dtsi | 1 +
drivers/mmc/host/meson-gx-mmc.c | 65 +++++++++++++++----
3 files changed, 57 insertions(+), 13 deletions(-)


 \ /
  Last update: 2019-05-13 11:16    [W:0.141 / U:4.684 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site