lkml.org 
[lkml]   [2019]   [May]   [10]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: [PATCH v2 0/4] Add reset controller support for BM1880 SoC
On Wed, May 08, 2019 at 10:23:15PM +0530, Manivannan Sadhasivam wrote:
> Hello,
>
> This patchset adds reset controller support for Bitmain BM1880 SoC.
> BM1880 SoC has two reset controllers each controlling reset lines of
> different peripherals. And the reset-simple driver has been reused here.
>

Sorry, above information was wrong! Actually there is only one reset
controller in this SoC. The other one (clk_rst) is a set of registers used
for clock gating functionality (clarified by Bitmain Engineer), so I will
remove it in next version.

Thanks,
Mani

> This patchset has been tested on 96Boards Sophon Edge board.
>
> Thanks,
> Mani
>
> Changes in v2:
>
> As per review from Philipp:
>
> * Reused reset_simple_active_low struct instead of a new one for bm1880
> * Splitted the SPDX license change to a separate commit
> * Added Reviewed-by tags from Rob and Philipp
>
> Manivannan Sadhasivam (4):
> dt-bindings: reset: Add devicetree binding for BM1880 reset controller
> arm64: dts: bitmain: Add reset controller support for BM1880 SoC
> reset: Add reset controller support for BM1880 SoC
> reset: Switch to SPDX license identifier for reset-simple
>
> .../bindings/reset/bitmain,bm1880-reset.txt | 18 +++
> arch/arm64/boot/dts/bitmain/bm1880.dtsi | 17 +++
> drivers/reset/Kconfig | 3 +-
> drivers/reset/reset-simple.c | 8 +-
> .../dt-bindings/reset/bitmain,bm1880-reset.h | 106 ++++++++++++++++++
> 5 files changed, 146 insertions(+), 6 deletions(-)
> create mode 100644 Documentation/devicetree/bindings/reset/bitmain,bm1880-reset.txt
> create mode 100644 include/dt-bindings/reset/bitmain,bm1880-reset.h
>
> --
> 2.17.1
>

\
 
 \ /
  Last update: 2019-05-10 10:58    [W:0.046 / U:2.000 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site