lkml.org 
[lkml]   [2019]   [Apr]   [6]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH RFC] staging: wilc1000: give usleep_range a range
Date
usleep_range() is called in non-atomic context so there is little point
in setting min==max the jitter of hrtimer is determined by interruptions
anyway. usleep_range can only perform the intended coalescence if some
room for placing the hrtimer is provided. Given the range of milliseconds
the delay will be anything from 2 to a few anyway - so make it 2-5 ms.

Signed-off-by: Nicholas Mc Guire <hofrat@osadl.org>
---

Problem located with an experimental coccinelle script
./drivers/staging/wilc1000/wilc_wlan.c:411:4-16: WARNING: inefficient usleep_range with range 0 (min==max)
./drivers/staging/wilc1000/wilc_wlan.c:426:4-16: WARNING: inefficient usleep_range with range 0 (min==max)

Someone that knows the motivation for setting the time to 2 millisecond
might need to check if the 2 milliseconds where seen as tollerable max or
min - I'm assuming it was the min so extending.

Patch was compile tested with: x86_64_defconfig + Staging=y,
WILC1000_SDIO=m, WILC1000_SPI=m, WILC1000=m

Patch is against 5.1-rc3 (localversion-next is -next-20190405)

drivers/staging/wilc1000/wilc_wlan.c | 4 ++--
1 file changed, 2 insertions(+), 2 deletions(-)

diff --git a/drivers/staging/wilc1000/wilc_wlan.c b/drivers/staging/wilc1000/wilc_wlan.c
index c238969..42da533 100644
--- a/drivers/staging/wilc1000/wilc_wlan.c
+++ b/drivers/staging/wilc1000/wilc_wlan.c
@@ -408,7 +408,7 @@ void chip_wakeup(struct wilc *wilc)
wilc->hif_func->hif_write_reg(wilc, 1, reg & ~BIT(1));

do {
- usleep_range(2 * 1000, 2 * 1000);
+ usleep_range(2 * 1000, 5 * 1000);
wilc_get_chipid(wilc, true);
} while (wilc_get_chipid(wilc, true) == 0);
} while (wilc_get_chipid(wilc, true) == 0);
@@ -423,7 +423,7 @@ void chip_wakeup(struct wilc *wilc)
&clk_status_reg);

while ((clk_status_reg & 0x1) == 0) {
- usleep_range(2 * 1000, 2 * 1000);
+ usleep_range(2 * 1000, 5 * 1000);

wilc->hif_func->hif_read_reg(wilc, 0xf1,
&clk_status_reg);
--
2.1.4
\
 
 \ /
  Last update: 2019-04-06 14:07    [W:0.072 / U:0.848 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site