lkml.org 
[lkml]   [2019]   [Apr]   [6]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: [PATCH v4 1/2] dt-bindings: Document MIPID02 bindings
On Sat, Apr 06, 2019 at 01:35:25PM +0300, Sakari Ailus wrote:
> Hi Mickael,
>
> On Wed, Mar 27, 2019 at 10:55:43AM +0100, Mickael Guene wrote:
> > This adds documentation of device tree for MIPID02 CSI-2 to PARALLEL
> > bridge.
> >
> > Signed-off-by: Mickael Guene <mickael.guene@st.com>
> > ---
> >
> > Changes in v4:
> > - Fix and clarify endpoints properties documentation
> >
> > Changes in v3: None
> > Changes in v2:
> > - Add precision about first CSI-2 port data rate
> > - Document endpoints supported properties
> > - Rename 'mipid02@14' into generic 'csi2rx@14' in example
> >
> > .../bindings/media/i2c/st,st-mipid02.txt | 82 ++++++++++++++++++++++
> > MAINTAINERS | 7 ++
> > 2 files changed, 89 insertions(+)
> > create mode 100644 Documentation/devicetree/bindings/media/i2c/st,st-mipid02.txt
> >
> > diff --git a/Documentation/devicetree/bindings/media/i2c/st,st-mipid02.txt b/Documentation/devicetree/bindings/media/i2c/st,st-mipid02.txt
> > new file mode 100644
> > index 0000000..754a175
> > --- /dev/null
> > +++ b/Documentation/devicetree/bindings/media/i2c/st,st-mipid02.txt
> > @@ -0,0 +1,82 @@
> > +STMicroelectronics MIPID02 CSI-2 to PARALLEL bridge
> > +
> > +MIPID02 has two CSI-2 input ports, only one of those ports can be active at a
> > +time. Active port input stream will be de-serialized and its content outputted
> > +through PARALLEL output port.
> > +CSI-2 first input port is a dual lane 800Mbps per lane whereas CSI-2 second
> > +input port is a single lane 800Mbps. Both ports support clock and data lane
> > +polarity swap. First port also supports data lane swap.
> > +PARALLEL output port has a maximum width of 12 bits.
> > +Supported formats are RAW6, RAW7, RAW8, RAW10, RAW12, RGB565, RGB888, RGB444,
> > +YUV420 8-bit, YUV422 8-bit and YUV420 10-bit.
> > +
> > +Required Properties:
> > +- compatible: should be "st,st-mipid02"
>
> s/should/shall/ overall; other values aren't really valid in any of the
> cases.

As this is the only change and it's trivial, I can do that as well. Let me
know if that works for you.

--
Sakari Ailus

\
 
 \ /
  Last update: 2019-04-06 12:40    [W:0.098 / U:0.292 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site