lkml.org 
[lkml]   [2019]   [Apr]   [6]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: [PATCH 1/2] dt-bindings: rtc: add battery-low-hw-alarm property
On Wed, Apr 03, 2019 at 04:52:44PM +0200, Flavio Suligoi wrote:
> Some RTC devices have a battery-low automatic detection circuit.
> The battery-low event is usually reported with:
>
> - a bit change in a RTC status register
> - a hw signaling (generally using an interrupt generation), changing
> the hw level of a specific pin;
>
> The new property "battery-low-hw-alarm" enable the RTC to generate the
> hw signaling in case of battery-low event.
>
> Signed-off-by: Flavio Suligoi <f.suligoi@asem.it>
> ---
> Documentation/devicetree/bindings/rtc/rtc.txt | 3 +++
> 1 file changed, 3 insertions(+)
>
> diff --git a/Documentation/devicetree/bindings/rtc/rtc.txt b/Documentation/devicetree/bindings/rtc/rtc.txt
> index a97fc6a..f93a44d 100644
> --- a/Documentation/devicetree/bindings/rtc/rtc.txt
> +++ b/Documentation/devicetree/bindings/rtc/rtc.txt
> @@ -31,6 +31,9 @@ below.
> expressed in femto Farad (fF).
> The default value shall be listed (if optional),
> and likewise all valid values.
> +- battery-low-hw-alarm : Enable the "battery-low" output pin. This function
> + is available on the following devices:
> + - pcf2127 - pin used for alarm: INTn

Boolean? If there's cases where which pin is selectable, then we'd need
this to take a value. Not sure how likely that is?

Rob

\
 
 \ /
  Last update: 2019-04-06 08:08    [W:0.867 / U:3.512 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site