lkml.org 
[lkml]   [2019]   [Apr]   [2]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[v3 PATCH 2/6] dt-bindings: usb: add binding for Type-B GPIO connector driver
Date
It's used to support dual role switch via GPIO when use Type-B
receptacle, typically the USB ID pin is connected to an input
GPIO pin

Signed-off-by: Chunfeng Yun <chunfeng.yun@mediatek.com>
---
v3 changes:
1. treat type-B connector as a virtual device, but not child device of
USB controller's

v2 changes:
1. new patch to make binding clear suggested by Hans
---
.../bindings/usb/typeb-conn-gpio.txt | 49 +++++++++++++++++++
1 file changed, 49 insertions(+)
create mode 100644 Documentation/devicetree/bindings/usb/typeb-conn-gpio.txt

diff --git a/Documentation/devicetree/bindings/usb/typeb-conn-gpio.txt b/Documentation/devicetree/bindings/usb/typeb-conn-gpio.txt
new file mode 100644
index 000000000000..d2e1c4e01b6d
--- /dev/null
+++ b/Documentation/devicetree/bindings/usb/typeb-conn-gpio.txt
@@ -0,0 +1,49 @@
+USB Type-B GPIO Connector
+
+This is a virtual device used to switch dual role mode from the USB ID pin
+connected to an input GPIO pin.
+
+Required properties:
+- compatible : Should be "linux,typeb-conn-gpio"
+
+Sub-nodes:
+- connector : should be present.
+ - compatible : should be "usb-b-connector".
+ - id-gpios, vbus-gpios : either one of them must be present,
+ and both can be present as well.
+ - vbus-supply : can be present if needed when supports dual role mode.
+ see connector/usb-connector.txt
+
+- port : should be present.
+ see graph.txt
+
+Example:
+
+rsw_iddig: role_sw_iddig {
+ compatible = "linux,typeb-conn-gpio";
+ status = "okay";
+
+ connector {
+ compatible = "usb-b-connector";
+ label = "micro-USB";
+ type = "micro";
+ id-gpios = <&pio 12 GPIO_ACTIVE_HIGH>;
+ vbus-supply = <&usb_p0_vbus>;
+ };
+
+ port {
+ bconn_ep: endpoint@0 {
+ remote-endpoint = <&usb_role_sw>;
+ };
+ };
+};
+
+&mtu3 {
+ status = "okay";
+
+ port {
+ usb_role_sw: endpoint@0 {
+ remote-endpoint = <&bconn_ep>;
+ };
+ };
+};
--
2.20.1
\
 
 \ /
  Last update: 2019-04-03 04:12    [W:0.081 / U:2.896 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site