lkml.org 
[lkml]   [2019]   [Mar]   [6]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
From
Subject[PATCH V2 0/8] spi: lpspi: Fix bugs and Add some functions support
Date
Hi Mark,

Sorry for replying so late. This patchset contains changes based on your and other
reviewers' comments.

As subject, these fucntions support, including:
- Support i.MX8 series boards;
- Support cs-gpio fucntion;
- Support DMA mode for both master and salve mode.

These are some notes about cs-gpio and DMA:
- cs-gpio:
Because LPSPI driver don't use default implementation of
transfer_one_message(), I do the cs-gpio control way as same as the way
used in spi core;

- DMA:
Any frame length longer than half txfifosize will be sent by DMA mode.
For now, there are some limits:
1. The maximum transfer speed in master mode depends on the slave device,
at least 40MHz on i.MX8 series (tested by spi-nor on 8qm-lpddr4-arm2
base board);
2. The maximum transfer speed I test in slave mode is 15MHz(i.MX7ULP),
20MHz(i.MX8 series). In order to reach the maximum speed which is
mentioned in datasheet, the load of connect wires between master and
slave should be less than 15pF.

Each patch in this patchset should base on the previous one when applied.

Thank you!

Clark Wang (7):
spi: lpspi: Add i.MX8 boards support for lpspi
doc: lpspi: Document DT bindings for LPSPI clocks
spi: lpspi: add the error info of transfer speed setting
spi: lpspi: use the core way to implement cs-gpio function
spi: lpspi: add dma mode support
spi: lpspi: Add the missing NULL check
spi: lpspi: Code cleanup

Han Xu (1):
spi: lpspi: enable runtime pm for lpspi

.../devicetree/bindings/spi/spi-fsl-lpspi.txt | 10 +-
drivers/spi/spi-fsl-lpspi.c | 543 ++++++++++++++++--
2 files changed, 495 insertions(+), 58 deletions(-)

--
2.17.1

\
 
 \ /
  Last update: 2019-03-06 07:31    [W:0.086 / U:1.472 seconds]
©2003-2018 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site