lkml.org 
[lkml]   [2019]   [Mar]   [3]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
From
SubjectRE: Realtek r8822be kernel module does not negotiate 802.11ac connection
Date


> -----Original Message-----
> From: Arend Van Spriel [mailto:arend.vanspriel@broadcom.com]
>
> > Larry,
> >
> > Sorry about all these extra replies.  Shortly after I sent my last
> > message my access point started recognizing the connection as 802.11ac
> > with PHY Rate / Modulation Rate of 866.6 Mbps.  What is somewhat
> > misleading is the information reported by iwconfig (see bit rate below).
>
> My bet would be that it is nitrate at which beacon or probe response is
> received. Regardless I would suggest using iw in this day and age.
>
> Regards,
> Arend
>
> > $ iwconfig wlo1
> > wlo1      IEEE 802.11  ESSID:"XXXXXXXXXX-5G"
> >           Mode:Managed  Frequency:5.22 GHz  Access Point:
> > xx:xx:xx:xx:xx:xx
> >           Bit Rate=6.5 Mb/s   Tx-Power=23 dBm
> >           Retry short limit:7   RTS thr:off   Fragment thr:off
> >           Power Management:on
> >           Link Quality=70/70  Signal level=-40 dBm
> >           Rx invalid nwid:0  Rx invalid crypt:0  Rx invalid frag:0
> >           Tx excessive retries:0  Invalid misc:11   Missed beacon:0
> >
> > Sincerely,
> >
> > David R. Bergstein
>

It's because the initial version does not collect tx_rate report from the firmware.
So it just print out the initial value. Will be added in the next series. Thanks!

Yan-Hsuan

\
 
 \ /
  Last update: 2019-03-04 03:35    [W:0.074 / U:52.260 seconds]
©2003-2018 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site